Press | Command | Function |
|
|
|
|
|
|
0 | Stop | Stops message playback, recording, and room moni- |
|
| toring. |
|
|
|
1 | Play Outgoing | If an outgoing message is recorded, the TAD says, |
| Message | “Play announcement” and plays the out going mes- |
|
| sage. After the message plays, the TAD beeps once. |
|
| If no outgoing message is recorded, the TAD beeps |
|
| and announces, “No announcement.” |
|
|
|
2 | Change Outgoing | Records a new outgoing message. When the TAD |
| Message | beeps, announces “Record announcement,” and |
|
| beeps again, begin your new outgoing message. |
|
| When you finish, press 0. The TAD beeps. |
|
|
|
3 | Room Monitor | Monitors the room where the TAD is located. The TAD |
|
| announces “Room Monitor.” After 30 seconds, the |
|
| TAD beeps and monitoring stops. To stop monitoring |
|
| the room sooner, press 0. |
|
|
|
4 | Play All Messages | Plays all the recorded messages. When messages |
| (To see what com- | are recorded, the TAD beeps, announces the number |
| mands you can use | of messages recorded, and plays the messages. If no |
| at this point, see the | message is recorded, the TAD beeps and says, “No |
| table on Page 23.) | message.” |
|
|
|
5 | Play New Messages | Plays only new messages that have not already been |
| (To see what com- | played. If new messages are recorded, the TAD |
| mands you can use | beeps, announces the number of new messages, and |
| at this point, see the | plays them. If there are no new messages, the TAD |
| table on Page 23.) | beeps and says, “No new message.” |
|
|
|
6 | Erase All Messages | If some messages (but no new messages) are |
|
| recorded, the TAD sounds 2 beeps and erases all |
|
| messages. |
|
| If new messages are recorded, the TAD beeps and |
|
| announces, “New messages” but does not erase all |
|
| messages. |
|
| If no messages are recorded, the TAD beeps and |
|
| announces, “No Message.” |
|
|
|
22