Remote ANSWER-ON, Using Remote Commands

43-744.fm Page 21 Friday, August 13, 1999 2:10 PM

2.Press SKIP/MEMO or REPEAT/ CODE to set the first digit, then press PLAY/STOP. The TAD beeps, and the second digit flashes.

3.Press SKIP/MEMO or REPEAT/ CODE to set the second digit, then press PLAY/STOP. The TAD beeps, and the third digit flashes.

4.Press SKIP/MEMO or REPEAT/ CODE to set the third digit, then press PLAY/STOP. The TAD beeps, and the display shows the number of messages stored.

To see the new code, press and release

REPEAT/CODE.

REMOTE ANSWER-ON

Note: You must record an outgoing message before you can remotely set the TAD to answer calls.

Follow these steps to remotely set the TAD to answer calls.

1.Dial your phone number.

•If the TAD is set to answer-off and an OGM is recorded, it answers the call after 60 sec- onds and announces, “Answer

off.” If no OGM is recorded, the TAD announces, “Answer off, no announcement.” Record an OGM (see “Recording an Outgo- ing Message”).

•If the TAD is set to answer-on, it answers after about two or four rings.

2.Enter the remote operation security code. The TAD beeps

Note: If you do not enter each digit of the security code within 8 sec- onds, the TAD hangs up.

3.Press #.

•If the TAD was set to answer-off, the TAD announces, “Answer on.”

•If the TAD was set to answer-on, the TAD announces, “Answer off.”

USING REMOTE

COMMANDS

To use remote commands, you must enter the remote operation security code. If you do not enter each digit of the security code within 8 seconds, the TAD hangs up.

After the TAD beeps once to verify you entered the code correctly, you can en- ter the number(s) for the function(s) you want the TAD to perform.

Note: The TAD sounds 3 beeps if you press the wrong button.