Note: Be sure the keyhole slots on the bracket and the TAD are pointed in the same direction.
4.Align the wall plate’s two studs with the keyhole slots on the bottom of the TAD. Slide the TAD down onto the studs to secure the TAD to the wall plate.
5.Slide the handset clip up and out of its retaining slot in the base. Rotate the clip so the tab points up, then slide the clip back into its slot. Hang the handset on the base.
Directly on a Wall
1.Drill two holes 315/16 inches (100 mm) apart.
2.Thread a screw (not supplied) into each hole until the head extends only about 3/16 of an inch (5mm) from the wall.
3.Snap the supplied mounting bracket into the slots on the bottom of the TAD.
Note: Be sure the keyhole slots on the bracket and the TAD are pointed in the same direction.
4.Align the two screws with the key- hole slots on the bottom of the TAD. Slide the TAD down onto the screws to secure the TAD to the wall.
8