4.Route the adapter's cord through the strain relief slot on the base.
5.Plug the adapter into a standard AC outlet. PF (power failure) flashes on the digital display.
6.Lift the base's antenna to a vertical position.
On a Wall Plate or Wall
1.Plug one end of the supplied short modular cord into the TEL LINE jack on the back of the base as in “On a Desk,” Step 1, on Page 10.
2.Insert the supplied AC adapter’s barrel plug into the DC 9V AC ADAPTER jack as in “On a Desk,” Step 3 on Page 10.
3.Route the adapter’s cord through the strain relief slot on the bottom of the base.
4.Insert the mounting bracket’s tabs into the base’s tab slots then press down on the bracket’s clips to insert them into the clip slots.
5.Plug the modular cord’s other end into the wall plate jack, then align the bracket’s keyhole slots with the wall plate studs and slide the base downward to secure it.
6.Plug the adapter into a standard AC outlet. PF flashes on the display.
7.Lift the base’s antenna to a vertical position.
Note: To mount the TAD directly on a wall, you need two screws (not supplied) with heads that fit into the keyhole slots on the bottom of the base.
Follow the above steps, then apply these additional instructions for place- ment on a wall.
11