Radio Shack TAD-727 owner manual TAD Operation, Using the Handset to Control the TAD

Page 21

43-727.fm Page 21 Monday, December 20, 1999 4:28 PM

TAD OPERATION

You can use the base or the handset to control the TAD. With the handset, you set the remote operation personal identi- fication number (PIN), select the outgo-

ing message, record outgoing messages, memos, or telephone con- versation, turn the TAD on and off, play messages, and delete a current mes- sage. At the base, you can set the day and time, set the number of rings before the TAD answers an incoming call, se- lect the outgoing message, set incoming message recording time, record outgo- ing messages, memos, or telephone conversation, turn the TAD on and off, play and delete messages, and adjust the TAD's volume.

Note: While you are using the base to control the TAD, you can still answer in- coming calls with the handset or another phone on the same telephone line.

USING THE HANDSET TO CONTROL THE TAD

To control the TAD with the handset, press REMOTE in standby mode. The TALK/LOW BATT indicator on the hand- set lights, and two bars flash on the digi- tal display on the base.

The TAD announces the number of messages you have (if any). If the TAD has no messages, the TAD announces “You have no messages.” Then the TAD is ready to accept a command.

Note: If you need help during operation,

press STOP/HELP/ TONE. The TAD plays a series of voice prompts to guide you through the handset operation.

When you finish operating the TAD, wait until the TALK/LOW BATT indicator turns off or press REMOTE again.

SETTING THE NUMBER OF RINGS

Follow these steps to set how long the TAD waits before it answers a call (2 rings, 5 rings, or toll-saver).

Note: If you plan to check your messag- es by long distance, set the number of rings to toll-saver (see “Using the Toll- Saver” on Page 28).

1.Hold down ANSWER on the base until the TAD announces the num- ber of rings (“two”, “five” or “toll- saver”) and the display flashes the current setting 2, 5, or SA.

21

Image 21
Contents TAD-727 Telephone Features FeaturesTAD Features Fm Page 4 Monday, December 20, 1999 428 PM FCC Statement Read this Before InstallationImportant Safety Instructions Installation Contents Playing Messages Deleting Messages Adjusting the TADs Volume Installation Mounting the PhoneOn a Desk On a Wall Plate or Wall Connecting Charging Battery Pack Fm Page 13 Monday, December 20, 1999 428 PM Setting Dialing Mode Setting the RingersTurning the Ringers On or Off Setting the Handsets Ringer Volume Using Redial Adjusting Handset VolumeOUT of Range Signal Telephone OperationUsing the Intercom Using FlashPaging from the Base to the Handset Memory DialingPaging from the Handset to the Base Storing a NumberChain-Dialing Service Numbers Entering a PauseDialing a Memory Number Testing Stored Emergency Numbers Using a HeadsetUsing the Handset to Control the TAD Setting the Number of RingsTAD Operation Setting the DAY Time Selecting AN Outgoing Message Setting the TAD to Answer Calls Recording a Memo Screening CallsUsing the Handset Using the BasePlaying Messages Deleting Messages Adjusting the Tads VolumeUsing the TOLL-SAVER Accessing the TAD RemotelyRemote Operation Press Problem Suggestion TroubleshootingFm Page 31 Monday, December 20, 1999 428 PM Care and Maintenance Replacing Battery Pack Lightning FCC Wants YOU to KnowFm Page 35 Monday, December 20, 1999 428 PM RadioShack