Radio Shack TAD-727 owner manual Setting the TAD to Answer Calls

43-727.fm Page 24 Monday, December 20, 1999 4:28 PM

2.When finished, press OGM REC again (or press STOP). The TAD beeps, plays back the message, then beeps again. The display shows A (or AO if you set it to announcement-only), and the num- ber of messages (if the TAD has new messages) alternately. The TAD is now ready to answer calls.

You can also record your message us- ing the handset. Press REMOTE, and af- ter hearing the number of messages, follow these steps.

1.Press OGM REC/1 on the handset twice within 2 seconds. A beep sounds. Then speak your outgoing message into the handset.

2. When finished, press OGM REC/1 again (or press STOP/HELP/ TONE). The handset beeps, then plays back the message.

SETTING THE TAD TO ANSWER CALLS

To set the TAD to answer calls, press ANSWER on the base. The TAD plays the current outgoing message, then dis- plays A (or AO if set to announcement- only). Press ANSWER again to select be-

24

tween the prerecorded or your own mes- sage.

To turn off the TAD, press STOP except while any message is playing back. The TAD announces “Answer off.”

To turn the TAD on and off from the handset, press REMOTE so the TALK/ LOW BATT indicator lights. You hear the TAD announce the number of cur- rently recorded messages, If there are no messages, the TAD announces “No messages”. Repeatedly press ANS/4 when you hear the announcement to turn the TAD on, select between the pre- recorded or your own message, or turn off the TAD.

Note: If the incoming message memory is full (59 messages including your own outgoing messages or less than 15 sec- onds left), the TAD announces “No re- maining time”, F flashes on the digital display. The TAD does not answer calls.