Radio Shack TAD-727 owner manual Setting the DAY Time

Page 22

43-727.fm Page 22 Monday, December 20, 1999 4:28 PM

2.Repeatedly press PREVIOUS or SKIP on the base until the TAD announces and displays the number of rings you desire – “two” so the TAD answers on the second ring, “five” for fifth ring, or “toll saver” when you want to use the toll-saver function.

PREVIOUS

PLAY/

REPEAT

SKIP

3.Press ANSWER or PLAY/REPEAT/

. The TAD sounds a long beep and announces the selected num- ber of rings.

Note: Press each button within 30 sec- onds. If you take longer, the setting pro- cedure is canceled automatically.

SETTING THE DAY

AND TIME

You must set the day and time so the TAD can record the correct day and time of each message.

1.Hold down STOP on the base until a long beep sounds. The TAD announces the day of the week. CL flashes on the digital display.

STOP

2.Press PREVIOUS or SKIP until the TAD announces the correct day of the week.

3.Press PLAY/REPEAT/ .The TAD announces the hour and “AM” or “PM.”

4.Press PREVIOUS or SKIP until the TAD announces the correct hour, including AM or PM.

5.Press PLAY/REPEAT/ .The TAD announces the minute.

6.Press PREVIOUS or SKIP until the TAD announces the correct minute.

Holding down PREVIOUS or SKIP advances the minute rapidly and announces minutes in 10 minute increments. Release PREVIOUS or SKIP and the TAD announces the minute setting. If you advance too far when holding down PREVIOUS or SKIP, press the opposite button.

7.Press PLAY/REPEAT/ . The TAD announces the minute and sounds a beep. Then the seconds start to count from 0.

22

Image 22
Contents TAD-727 Features Telephone FeaturesTAD Features Fm Page 4 Monday, December 20, 1999 428 PM Read this Before Installation FCC StatementImportant Safety Instructions Installation Contents Playing Messages Deleting Messages Adjusting the TADs Volume Mounting the Phone InstallationOn a Desk On a Wall Plate or Wall Connecting Charging Battery Pack Fm Page 13 Monday, December 20, 1999 428 PM Setting the Ringers Setting Dialing ModeTurning the Ringers On or Off Setting the Handsets Ringer Volume OUT of Range Signal Adjusting Handset VolumeUsing Redial Telephone OperationUsing Flash Using the IntercomPaging from the Handset to the Base Memory DialingPaging from the Base to the Handset Storing a NumberEntering a Pause Chain-Dialing Service NumbersDialing a Memory Number Using a Headset Testing Stored Emergency NumbersSetting the Number of Rings Using the Handset to Control the TADTAD Operation Setting the DAY Time Selecting AN Outgoing Message Setting the TAD to Answer Calls Screening Calls Recording a MemoUsing the Base Using the HandsetPlaying Messages Adjusting the Tads Volume Deleting MessagesAccessing the TAD Remotely Using the TOLL-SAVERRemote Operation Press Troubleshooting Problem SuggestionFm Page 31 Monday, December 20, 1999 428 PM Care and Maintenance Replacing Battery Pack FCC Wants YOU to Know LightningFm Page 35 Monday, December 20, 1999 428 PM RadioShack