Radio Shack TAD-727 owner manual Connecting Charging Battery Pack

43-727.fm Page 12 Monday, December 20, 1999 4:28 PM

		15	/16
1. Drill two holes 3 /16
			5
inches	(100	mm)
apart. Then thread
a screw into		each	15
hole,	letting	the
			3 /16
5heads extend about
/16 inch (8 mm)
from the wall.

2.Plug one end of the supplied long modular cord into the TEL LINE jack on the back of the base.

3.Align the bracket’s keyhole slots with the mounting screws and slide the base downward to secure it.

CONNECTING AND

CHARGING THE

BATTERY PACK

The TAD-727 comes with a recharge- able nickel-cadmium battery pack in the handset but not connected. Before using your phone, you must connect the bat- tery pack, then charge it for about 12 hours.

12

1.Press down and slide off the battery pack compartment cover.

2.Lift the battery pack out of the com- partment.

3.Plug the battery pack's connector into the socket in the compartment (the connector fits only one way), route the battery pack's leads through the strain relief slot and place the battery pack into the com- partment.

Note: When you connect the bat- tery, the TALK/LOW/BATT indicator flashes (when in the phone is not in use) indicating that the security access protection code on the hand- set was lost.

To reset the code, return the hand- set to the base for about 2 seconds.

4. Replace the cover.