Radio Shack TAD-1015 owner manual Fm Page 24 Friday, August 13, 1999 314 PM

Page 24

43-774.fm Page 24 Friday, August 13, 1999 3:14 PM

If you turn the base’s ringer off, the TAD does not beep when it re- ceives new messages. See “Turn- ing the Base’s Ringer Off/On” on Page 14.

Press PLAY/SKIP on the base, or press REMOTE then PLAY/2 on the handset. The TAD announces the number of messages and whether the messages are old (already listened to) or new. Then each new message plays, followed by the day and time it was recorded.

When you have both old and new messages, the TAD first plays back only new messages. After you have listened to the new messages, you can listen to all messages (old then new) by pressing PLAY again.

While playing back the messages, the display shows the number of the cur- rent message. For example, if you have a total of four messages (one old, three new), pressing PLAY dis- plays 2 (the first new message).

If there are no messages when you press PLAY, five beeps sound and the TAD announces “You have no mes- sages.”

24

Notes:

If the TAD detects a busy signal or silence for more than 7 seconds while recording a message, it stops recording and releases the call.

When you play back messages using the handset, the message number does not appear on the display.

To skip to the next message, press PLAY/SKIP (or SKIP/3 on the handset).

To play the current message again, press REPEAT (or REPEAT/1 on the handset).

Note: If you press REPEAT within 2 seconds after a message begins play- ing, the TAD repeats the previous message.

Image 24
Contents TAD-1015 Features Telephone FeaturesTAD Features Announcement Only lets you play Read this Before Installation FCC StatementContents Using the Toll-Saver Accessing the TAD by Remote Installation Selecting aLocation Placing the BaseMounting the Base on a Wall Plate Upper Grooves Lower Mounting the Base Directly on the Wall Removing the Protective Sheet Connecting and Charging the Battery Pack PreparationSetting the Dialing Mode Turning the BASE’S Ringer OFF/ON Using Redial Telephone OperationMaking Receiving Calls Changing ChannelUsing Flash PagingMemory Dialing Storing a Number in MemoryChain-Dialing Service Numbers Testing Stored Emergency NumbersEntering a Pause Dialing a Stored NumberSetting the Number of Rings TAD OperationSetting the DAY and Time Setting the Remote Operation PINSelecting AN Outgoing Message Recording an Outgoing MessageSetting the TAD to Answer Calls Screening Calls Recording a MemoPlaying Messages Fm Page 24 Friday, August 13, 1999 314 PM Adjusting the TAD’S Volume Deleting MessagesUsing the TOLL-SAVER Accessing the TAD by RemoteRemote Operation Fm Page 27 Friday, August 13, 1999 314 PM Troubleshooting Problem SuggestionFm Page 29 Friday, August 13, 1999 314 PM Care and Maintenance Replacing Battery Pack FCC Wants YOU to Know Lightning Fm Page 34 Friday, August 13, 1999 314 PM Fm Page 35 Friday, August 13, 1999 314 PM RadioShack