Radio Shack TAD-1015 Telephone Operation, Making Receiving Calls, Changing Channel, Using Redial

Page 15

43-774.fm Page 15 Friday, August 13, 1999 3:14 PM

TELEPHONE OPERATION

MAKING AND

RECEIVING CALLS

To make or answer a call, lift the hand- set. Or, if the handset is off the base, press TALK. The BATT LOW indicator on the handset and the IN USE indica- tor on the base light.

To end a call, place the handset on the base or press TALK on the handset.

Note: If you press TALK to hang up and the phone does not disconnect, press TALK again while holding the handset closer to the base or place the handset on the base.

CHANGING THE

CHANNEL

If you notice interference, static, or noise during a call, press CH (channel) on the handset to find a clearer chan- nel.

The TAD-1015 changes to a different channel each time you press CH.

Note: If the handset is too far from the base, the channel might not change. Move closer to the base and try again.

USING REDIAL

REDIAL lets you dial the last number dialed. When you hear a dial tone, sim- ply press REDIAL.

Notes:

The redial memory holds up to 32 digits, so you can redial long- distance as well as local num- bers.

The redial memory also holds pause entries. See “Entering a Pause” on Page 18.

The redial memory does not store a flash entry or any digits you press after FLASH (see “Using Flash” on Page 16).

15

Image 15
Contents TAD-1015 Features Telephone FeaturesTAD Features Announcement Only lets you play FCC Statement Read this Before InstallationContents Using the Toll-Saver Accessing the TAD by Remote Placing the Base InstallationSelecting a LocationMounting the Base on a Wall Plate Upper Grooves Lower Mounting the Base Directly on the Wall Removing the Protective Sheet Preparation Connecting and Charging the Battery PackSetting the Dialing Mode Turning the BASE’S Ringer OFF/ON Changing Channel Using RedialTelephone Operation Making Receiving CallsPaging Using FlashStoring a Number in Memory Memory DialingDialing a Stored Number Chain-Dialing Service NumbersTesting Stored Emergency Numbers Entering a PauseTAD Operation Setting the Number of RingsSetting the Remote Operation PIN Setting the DAY and TimeRecording an Outgoing Message Selecting AN Outgoing MessageSetting the TAD to Answer Calls Screening Calls Recording a MemoPlaying Messages Fm Page 24 Friday, August 13, 1999 314 PM Deleting Messages Adjusting the TAD’S VolumeUsing the TOLL-SAVER Accessing the TAD by RemoteRemote Operation Fm Page 27 Friday, August 13, 1999 314 PM Problem Suggestion TroubleshootingFm Page 29 Friday, August 13, 1999 314 PM Care and Maintenance Replacing Battery Pack FCC Wants YOU to Know Lightning Fm Page 34 Friday, August 13, 1999 314 PM Fm Page 35 Friday, August 13, 1999 314 PM RadioShack