Remote Operation, Using the TOLL-SAVER

43-774.fm Page 26 Friday, August 13, 1999 3:14 PM

REMOTE OPERATION

USING THE TOLL-SAVER

When you call the TAD with RING TIME set to TS (toll-saver), it answers after about two rings if you have new messages (ones you have not listened to). If there are no new messages, the TAD waits for about five rings before it answers. This gives you time to hang up before the TAD answers so you can avoid any long-distance charges.

ACCESSING THE TAD BY REMOTE

While you are away from the phone’s base, you can use a touch-tone phone or a pulse (rotary) phone with a pocket tone dialer to enter your PIN and do any of the following:

•Set the TAD to answer calls

•Listen to your messages

•Record a new announcement

•Record a memo

•Erase messages

•Turn the TAD off

Note: You cannot access the TAD from another telephone on the same line as your TAD-1015.

1.Dial your phone number and wait for the TAD to answer.

If the TAD is not set to answer calls, let the phone ring 10 times. The TAD automatically turns itself on to answer your call then turns

off when you hang up (unless you set the TAD to answer calls).

2.When the outgoing message

begins, press then enter your 2-digit PIN within 2 seconds.

The message stops, and the TAD announces “You have XX new message(s)” or “You have no messages,” then plays a series of voice prompts to guide you through remote operation.

3.Press , then, within 2 seconds, press the number key for the com- mand you want.

Press:		To:


	1	Repeat current mes-


		sage.

	2	Play messages and


		memos.

	3	Skip current message


		during playback.

	4	Delete current mes-


		sage during playback.

	5	Record a memo.



	6	Set the TAD to answer/


		not answer calls.

	7	Stop playback of mes-


		sages, memos, or the
		outgoing announce-
		ment; end recording of
		memo and outgoing
		announcement.

	8	Record a new outgoing


		message.

	0	Play the voice prompts


		again.