Proxim AP-2000 manual Set Rogue Access Point Detection RAD Parameters

Using the Command Line Interface (CLI)

Accounting Update Interval	: 0
Accounting Inactivity Timer	: 5
Index	: 4
Primary/Backup	: Primary
Profile Name	: Management Access
Server Status	: notReady
Server Addressing Format	: ipaddr
IP Address/Host Name	: 0.0.0.0
Destination Port	: 1812
VLAN Identifier	: -1
MAC Address Format	: dashdelimited
Response Time	: 3
Maximum Retransmission	: 3
Authorization Lifetime	: 0
Accounting Update Interval	: 0
Accounting Inactivity Timer	: 5
Index	: 4
Primary/Backup	: Backup
Profile Name	: Management Access
Server Status	: notReady
Server Addressing Format	: ipaddr
IP Address/Host Name	: 0.0.0.0
Destination Port	: 1812
VLAN Identifier	: -1
MAC Address Format	: dashdelimited
Response Time	: 3
Maximum Retransmission	: 3
Authorization Lifetime	: 0
Accounting Update Interval	: 0
Accounting Inactivity Timer	: 5

Set Rogue Access Point Detection (RAD) Parameters

The Rogue AP Detection (RAD) feature enables an additional security level for wireless LAN deployments. The RAD feature provides a mechanism for detecting Rogue Access Points by utilizing the coverage of the trusted Access Point deployment.

The Rogue AP Scan employs background scanning using low-level 802.11 scanning functions for effective wireless detection of Access Points in its coverage area with minimal impact on the normal operation of the Access Point.

The set radstatus command enables Rogue Access Point Detection. The scan repetition duration (radscanint) is also configurable.If the Access Point uses directional antennas to provide directional coverage, then the interface bitmask (radifbitmask) can be configured to maximize the scanning coverage area.

[Device-Name]>set radstatus enable [Device-Name]>set radscanint <15-1440>

[Device-Name]>set radifbitmask <4 (WiF A), 8 (WiF B), or 12 (both interfaces)> [Device-Name]>show rad

Figure A-16 Results of “show rad” CLI command

155