Using the Command Line Interface (CLI)

NOTE

Proxim recommends changing your default passwords immediately. To perform this operation using CLI commands, refer to Change Passwords.

Set Basic Configuration Parameters using CLI Commands

There are a few basic configuration parameters that you may want to setup right away when you receive the AP. For example:

Set System Name, Location and Contact Information

Set Static IP Address for the AP

Download an AP Configuration File from your TFTP Server

Set up Auto Configuration

Set Network Names for the Wireless Interface

Enable and Configure TX Power Control for the Wireless Interface(s)

Configure SSID (Network Name) and VLAN Pairs, and Profiles

Download an AP Configuration File from your TFTP Server

Backup your AP Configuration File

Set System Name, Location and Contact Information

[Device-Name]>set sysname <system name> sysloc <Unit Location> [Device-Name]>set sysctname <Contact Name (person responsible for system)> [Device-Name]>set sysctphone <Contact Phone Number> sysctemail <Contact E-mail address> [Device-Name]>show system

Figure A-12 Result of “show system” CLI Command

Set Static IP Address for the AP

NOTE

The IP Subnet Mask of the AP must match your network’s Subnet Mask.

[Device-Name]> [Device-Name]> [Device-Name]> [Device-Name]> [Device-Name]>

set ipaddrtype static

set ipaddr <fixed IP address of unit> set ipsubmask <IP Mask>

set ipgw <gateway IP address> show network

Change Passwords

[Device-Name]> [Device-Name]> [Device-Name]> [Device-Name]> [Device-Name]>

passwd <Old Password> <New Password> <Confirm Password> (CLI password) set httppasswd <New Password> (HTTP interface password)

set snmprpasswd <New Password> (SNMP read password) set snmprwpasswd <New Password> (SNMP read/write)

set snmpv3authpasswd <New Password> (SNMPv3 authentication password)

144

Page 144
Image 144
Proxim AP-2000 Set Basic Configuration Parameters using CLI Commands, Set System Name, Location and Contact Information