Proxim AP-2000 manual 130

Troubleshooting the AP-2000

Follow these steps to assign the AP an IP address:

1.Open your terminal emulation program (like HyperTerminal) and set the following connection properties:

•Com Port: <COM1, COM2, etc., depending on your computer>

•Baud rate: 9600

•Data Bits: 8

•Stop bits: 1

•Flow Control: None

•Parity: None

2.Under File -> Properties -> Settings -> ASCII Setup, enable the Send line ends with line feeds option. Result: HyperTerminal sends a line return at the end of each line of code.

3.Press the RESET button on the AP (see RELOAD and RESET Buttons to identify the location of the RESET button).

Result: The terminal display shows Power On Self Tests (POST) activity, and then displays a CLI prompt, similar to the example below. This process may take up to 90 seconds.

[Device name]> Please enter password:

4.Enter the CLI password (default is public).

Result: The terminal displays a welcome message and then the CLI Prompt:

[Device name]>

5.Enter show ip. Result: Network parameters appear:

Figure 7-2 Result of “show ip” CLI Command

6.Change the IP address and other network values using set and reboot CLI commands, similar to the example below (use your own IP address and subnet mask). Note that IP Address Type is set to Dynamic by default. If you have a DHCP server on your network, you should not need to manually configure the Access Point’s IP address; the Access Point will obtain an IP address from the network’s DHCP server during boot-up.

Result: After each entry the CLI reminds you to reboot; however wait to reboot until all commands have been entered.

[Device name]> set ipaddrtype static [Device name]> set ipaddr <IP Address> [Device name]> set ipsubmask <IP Subnet Mask> [Device name]> set ipgw <Default Gateway IP Address>

[Device name]> show ip (to confirm your new settings)

[Device name]> reboot 0

7.After the AP reboots, verify the new IP address by reconnecting to the CLI and enter a show ip command. Alternatively, you can ping the AP from a network computer to confirm that the new IP address has taken effect.

8.When the proper IP address is set, use the HTTP interface or CLI over Telnet to configure the rest of the unit’s operating parameters.

130