Proxim AP-2000 manual Alarms Parameters, Snmp Table Host Table Parameters, Syslog Parameters

Using the Command Line Interface (CLI)

Port Number	Octet String	User Defined	RW	portnum
		(there are also 4
		pre-defined protocols:
		Index 1: NetBios Name
		Service – 137, Index 2:
		NetBios Datagram
		Service – 138, Index 3:
		NetBios Session
		Service – 139, Index 4:
		SNMP Service – 161)
Protocol Name	DisplayString	User Defined	RW	protoname
		(there are also 4
		pre-defined protocols,
		see Port Number above)
Interface Bitmask	Integer32	0 or 2 - no interfaces	RW	ifbitmask
		(disable)
		1 or 3 - Ethernet
		4 or 6 - Wireless A
		8 or 10 - Wireless B
		12 = Wireless A & B
		13 or 15 - all interfaces
		(default is 15)
Status (optional)	Integer	enable (default for new	RW	status
		entries)
		disable (default for
		pre-defined entries)
		delete

Alarms Parameters

SNMP Table Host Table Parameters

When creating table entries, you may either specifying the argument name followed by argument value. CLI applies default values to the omitted arguments. Due to the nature of the information, the only argument that can be omitted is the “comment” argument.

NOTE

Up to 10 entries can be added to the SNMP Trap Host Table.

Name	Type	Values	Access	CLI Parameter
SNMP Trap Host Table	Table	N/A	R	snmptraphosttbl
Table Index	Integer	User Defined	N/A	index
IP Address	IpAddress	User Defined	RW	ipaddr
Password	DisplayString	User Defined (up to 64	W	passwd
		characters)
Comment (optional)	DisplayString	User Defined (up to 254	RW	cmt
		characters)
Status (optional)	Integer	enable (default)	RW	status
		disable
		delete

Syslog Parameters

The following parameters configure the Syslog settings.

Name	Type	Values	Access	CLI
Syslog	Group	N/A	R	syslog
Syslog Status	Integer	enable	RW	syslogstatus
		disable (default)
Syslog Port	Octet String	514	R	syslogport

172