Proxim AP-2000 manual Wireless Interface Parameters, 802.11a Only Parameters

Using the Command Line Interface (CLI)

Interface Parameters

Wireless Interface Parameters

The wireless interface group parameter is wif. For Dual-radio APs, Slot A uses table index 3 and Slot B uses table index 4.

Common Parameters to 802.11a, 802.11b, and 802.11b/g APs

Name	Type	Values		Access	CLI Parameter
Wireless Interfaces	Group	N/A		R	wif
Table Index	Integer	3	(Slot A) or 4 (Slot B)	R	index
Network Name	DisplayString	2	– 31 characters	RW	netname
		My Wireless Network
		(default)
Auto Channel Select (ACS)1	Integer	enable (default)		RW	autochannel
		disable
DTIM Period	Integer	1	– 255	RW	dtimperiod
		1	= default
RTS/CTS Medium Reservation	Integer	0	– 2347	RW	medres
		Default is 2347 (off)
MAC Address	PhyAddress	12 hex digits		R	macaddr
Closed System	Integer	enable		RW	closedsys
		disable (default)
Wireless Service Status	Integer	1	= resume	RW	wssstatus
		2= shutdown
Supported Frequency Channels	Octet String	Depends on Regulatory		R	suppchannels
		Domain
Load Balancing	Integer	enable (default)		RW	ldbalance
		disable

Note 1: For 802.11a APs in Europe, Auto Channel Select is a read-only parameter; it is always enabled.

802.11a Only Parameters

Name	Type	Values	Access	CLI Parameter
Operating Frequency Channel	Integer	Varies by regulatory	RW	channel
		domain and country. See
		802.11a Channel
		Frequencies
Supported Data Rates	Octet String	See Transmit Rate,	R	suppdatarates
		below
Transmit Rate	Integer32	0 - Auto Fallback	RW	txrate
		(default)
		6 Mbits/sec
		9 Mbits/sec
		12 Mbits/sec
		18 Mbits/sec
		24 Mbits/sec
		36 Mbits/sec
		48 Mbits/sec
		54 Mbits/sec
Physical Layer Type	Integer	ofdm (orthogonal	R	phytype
		frequency division
		multiplexing) for 802.11a
SuperMode	Integer	enable	RW	supermode
		disable (default)
TurboMode	Integer	enable	RW	turbomode
		disable (default)

Note 1: Super Mode must be enabled first on the wireless interface before Turbo Mode can be enabled.

162