Proxim AP-2000 manual Other Parameters, Iapp Parameters

Using the Command Line Interface (CLI)

Configuring a Security Profile with WPA-PSK Security Mode

set secprofiletbl <index> secmode wpa-psk passphrase <value> status enable

Example: set secprofiletbl 6 secmode wpa-psk passphrase 12345678 status enable

Configuring a Security Profile with 802.11i Security Mode

set secprofiletbl <index> secmode 802.11i rekeyint <value> status enable

Example: set secprofiletbl 7 secmode 802.11i rekeyint 900 status enable

Configuring a Security Profile with 802.11i-PSK Security Mode

set secprofiletbl <index> secmode 802.11i-psk passphrase <value> status enable

Example: set secprofiletbl 8 secmode 802.11i-psk passphrase 12345678 status enable

Other Parameters

IAPP Parameters

Name	Type	Values	Access	CLI Parameter
IAPP	Group	N/A	R	iapp
IAPP Status	Integer	enable (default)	RW	iappstatus
		disable
Periodic Announce	Integer	80	RW	iappannint
Interval (seconds)		120 (default)
		160
		200
Announce Response	Integer	2 seconds	R	iappannresp
Time
Handover Time-out	Integer	410 ms	RW	iapphandtout
		512 ms (default)
		614 ms
		717 ms
		819 ms
Max. Handover	Integer	1 - 4 (default 4)	RW	iapphandretx
Retransmissions
Send Announce	Integer	enable (default)	RW	iappannreqstart
Request on Startup		disable

NOTE

These parameters configure the Inter Access Point Protocol (IAPP) for roaming. Leave these settings at their default value unless a technical representative asks you to change them.

SpectraLink VoIP Parameters (802.11b and bg Modes Only)

These parameters enable or disable the SpectraLink Voice over IP feature.

The Spectralink Legacy Support parameter should be enabled if the AP is operating in 802.11bg mode and legacy

802.11Spectralink telephones are used. This parameter will set the basic rates of the AP to be 1 and 2 Mbps in 802.11bg mode and will allow old telephones that operate only at the 1 and 2 Mbps basic rate to connect to the AP.

Name	Type	Values	Access	CLI Parameter
Spectralink VoIP	Group	N/A	R	spectralink
Spectralink VoIP Status	Integer	enable	RW	speclinkstatus
		disable (default)
Spectralink Legacy	Integer	enable	RW	speclinklegacysupport
Support		disable (default)

178