Proxim AP-2000 manual Set Ethernet Speed and Transmission Mode, Set Interface Management Services

Using the Command Line Interface (CLI)

Set the Multicast Rate (802.11b Only)

[Device-Name]>set wif <index> multrate <1,2,5.5,11 (Mbits/sec)>

NOTE

The Distance Between APs must be set before the Multicast Rate.

Enable/Disable Super Mode (802.11a/g only)

[Device-Name]>set wif 3 super <enable/disable>

Enable/Disable Turbo Mode (802.11a/g only)

[Device-Name]>set wif 3 turbo <enable/disable>

NOTE

Super mode must be enabled on the interface before Turbo mode can be enabled.

Set Ethernet Speed and Transmission Mode

[Device-Name]>set etherspeed <value (see below)> [Device-Name]>reboot 0

Ethernet Speed and Transmission Mode			Value
10	Mbits/sec - half duplex		10halfduplex
10	Mbits/sec - full duplex		10fullduplex
10	Mbits/sec - auto duplex		10autoduplex
100		Mbits/sec - half duplex	100halfduplex
100		Mbits/sec - full duplex	100fullduplex
Auto Speed - half duplex			autohalfduplex
Auto Speed - auto duplex			autoautoduplex (default)

Set Interface Management Services

Edit Management IP Access Table

[Device-Name]>set mgmtipaccesstbl <index> ipaddr <IP address> ipmask <subnet mask>

Configure Management Ports

[Device-Name]> [Device-Name]> [Device-Name]>

set snmpifbitmask <(see below)> set httpifbitmask <(see below)> set telifbitmask <(see below)>

Choose from the following values:

Interface bitmask		Description
0 or 2	= disable (all interfaces)	All management channels disabled
1 or 3	= Ethernet only	Ethernet only enabled
4 or 6	= Wireless A only	Wireless A only enabled
8 or 10 = Wireless B only		Wireless B only enabled
12 = Wireless A and Wireless B		Wireless A and Wireless B enabled
13 or 15 = all interfaces		All management channels enabled

Set Communication Ports

[Device-Name]>set httpport <HTTP port number (default is 80)> [Device-Name]>set telport <Telnet port number (default is 23)>

150