Proxim AP-2000 manual 157

Using the Command Line Interface (CLI)

Access Point network objects are associated with Groups. The network objects are listed below and associated parameters are described in the following Parameter Tables:

•System Parameters - Access Point system information

–Inventory Management Information - Hardware, firmware, and software version information

•Network Parameters - IP and Network Settings

–IP Configuration Parameters - Configure the Access Point’s IP settings

—DNS Client for RADIUS Name Resolution - Configure the Access Point as a DNS client

–DHCP Server Parameters - Enable or disable dynamic host configuration

–Link Integrity Parameters - Monitor link status

•Interface Parameters - Configure Wireless and Ethernet settings

–Wireless Interface Parameters

—Wireless Distribution System (WDS) Parameters - Configure the WDS partnerships

–Wireless Interface SSID/VLAN/Profile Parameters - Configure the SSID and VLAN pairs and the security and RADIUS profiles for each pair. Up to 16 pairs can be configured per wireless interface.

–Wireless Distribution System (WDS) Security Table Parameters

–Ethernet Interface Parameters - Set the speed and duplex of the Ethernet port

•Management Parameters - Control access to the AP’s management interfaces

–SNMP Parameters - Set read and read/write passwords

–HTTP (web browser) Parameters - Set up the graphical web browser interface. If required, enable SSL and configure the SSL certificate passphrase.

–Telnet Parameters - Telnet Port setup

–Serial Port Parameters - Serial Port setup

–RADIUS Based Management Access Parameters - Configure RADIUS Based Management Access for HTTP and Telnet access.

–SSH Parameters - Enable SSH and configure the host key.

–TFTP Server Parameters - Set up for file transfers; specify IP Address, file name, and file type

–IP Access Table Parameters - Configure range of IP addresses that can access the AP

–Auto Configuration Parameters - Configure the Auto Configuration feature which allows an AP to be automatically configured by downloading a configuration file from a TFTP server during boot up.

•Filtering Parameters

–Ethernet Protocol Filtering Parameters - Control network traffic based on protocol type

–Static MAC Address Filter Table - Enable and disable specific addresses

–Proxy ARP Parameters - Enable or disable proxy ARP for wireless clients

–IP ARP Filtering Parameters - Control which ARP messages are sent to wireless clients based on IP settings

–Broadcast Filtering Table - Control the type of broadcast packets forwarded to the wireless network

–TCP/UDP Port Filtering - Filter IP packets based on TCP/UDP port

•Alarms Parameters

–SNMP Table Host Table Parameters - Enter the list of IP addresses that will receive alarms from the AP

–Syslog Parameters - Configure the AP to send Syslog information to network servers

•Bridge Parameters

–Spanning Tree Parameters - Used to help prevent network loops

–Storm Threshold Parameters - Set threshold for number of broadcast packets

–Intra BSS Subscriber Blocking - Enable or disable peer to peer traffic on the same AP

–Packet Forwarding Parameters - Redirect traffic from wireless clients to a specified MAC address

•RADIUS Parameters

–Set RADIUS Parameters - Configure RADIUS Servers and assign them to VLANs.

•Security Parameters - Access Point security settings

–MAC Access Control Parameter - Control wireless access based on MAC address

–Rogue Access Point Detection (RAD) Parameters - Enable and configure Rogue Access Point Detection.

–Hardware Configuration Reset - Disable or enable hardware configuration reset and configure a configuration reset password.

157