Note: The phone exits setting mode if a call
or page is received, or if you press or LINE 2.
ADJUSTING THE RINGER
The phone lets you control its base and handset ringer volume separately. You can choose from a high or low ringer setting or turn the ringer off for the base and the hand- set.
On the Handset
In the standby mode, press DEL/VOL to set the handset’s ringer volume. The display shows H_d][h >_]^ or H_d][h Bem.
You can also turn off the ringer. In the stand- by mode, press and hold DEL/VOL until the phone beeps and H_d][h E\\ appears. When
you place the handset
You can still make or receive a call even when the ringer is turned off. When you have an incoming call, the base unit (if you have not set RING VOL to OFF) and any other phone connected to the same line rings, and â9Wbbá appears on the handset’s display.
To turn the ringer back on, simply press DEL/ VOL. The ringer is restored at the H_d][h >_]^ setting.
On the Base
Set RING VOL on the back of the base to HI, LO, or OFF for each line (L1 and L2). With RING VOL set to OFF, the base’s ringer does not sound when a call is received, but the handset (when it is off the base with the ring- er not turned off) and any other phone con- nected to the same line still ring.
SETTING AUTO TALK
Your phone is preset so you must press LINE 1 or LINE 2 to answer a call. With auto talk turned on, you can answer a call by lifting the handset from the base (or any key on the handset if the handset is away from the base).
Note: Auto talk is set for each line separate- ly. For example, when you turn auto talk on for Line 1 only, you must press LINE 2 to an- swer a call on line 2.
Follow these steps to turn auto talk on or off.
1.Lift the handset and hold down CID/ HOLD until 9Wbb[h ?: I[jkf appears on the display with the pointer at B_d[ '.
2.Use ∗/TONE/6 or #/7 to select B_d[ ' or B_d[ (. Then press CONF/9.
3.A menu appears with 7kje JWba selected. Press SELECT/CH to change the setting. Ed or E\\ appears indicating the selected setting.
4.Press CID/HOLD and return the handset to the base.
SETTING CALLER ID/CALL WAITING
If you have Call Waiting and Caller ID ser- vice, you can set the phone to show Caller ID information for an incoming call even while you are already on the phone.
Note: Caller ID/Call Waiting function is set for each line separately.
1.Lift the handset and hold down CID/ HOLD until 9Wbb[h ?: I[jkf appears on the display with B_d[ ' selected.
2.Use ∗/TONE/6 or #/7 to select B_d[ ' or B_d[ (. Then press CONF/9.
14 | Installation |