Radio Shack 2.4 GHz 2-Line Digital Spread Spectrum Cordless Phone with Call Waiting/Caller ID

Page 20
8/INTCM.

Note: The paging ends in one minute if no- body answers. Press INTERCOM or 8/IN- TCM again.

To end an intercom call, press 8/INTCM or

INTERCOM.

During a call, you can page someone at ei- ther the base or the handset to join the con- versation. Press INTERCOM or

The current call is placed on hold.

To transfer the call, press INTERCOM or 8/ INTCM again when the person at the base or handset answers.

To start a 3-way call, tell the person at the base or handset to press the line button for the call, then press the same button twice on your keypad when they answer the page.

Notes:

You cannot page the base or handset if it is already in use.

If a call comes in during an intercom conversation, either of the intercom par- ties can answer the call as they normally would. Simply press the ringing line’s button. The intercom call automatically disconnects.

USING A HEADSET

You can talk with hands-free convenience using an optional headset that has a 3/32-inch (2.5-mm) plug. Contact your local Ra- dioShack store for a suitable headset.

To connect the headset, open the rubber cover on the side of the handset, then insert the headset’s plug into the jack.

Notes:

Connecting a headset disconnects the handset’s earpiece and microphone, but it does not affect the phone’s speaker- phone.

DEL/VOL on the handset also controls the connected headset’s volume.

If you place the handset on the base to recharge it while the headset is con- nected, be sure the handset seats prop- erly.

With a headset connected, you make or an- swer calls as usual using the keys on the handset.

You can use a handset holder (available from your local RadioShack store) to hang the handset on your belt for greater conve- nience. When you finish using the headset, disconnect it from the handset and close the rubber cover to protect the jack.

20

Basic Operation

Image 20
Contents GHz 2-Line Digital Spread Spectrum Cordless Phone FCC Statement Read this Before Installation Important InformationLightning Important Safety InstructionsFCC Wants YOU to Know Important Information Battery Safety Instructions Save These InstructionsContents Troubleshooting Caller ID Operation Handset OnlyFeatures Facedown or Faceup Handset ChargingImportant Caller ID Information Mounting the Phone InstallationConnecting to the Phone Lines On a Desk Top On a Wall Plate or WallCONNECTING, CHARGING, and Replacing the Battery Pack Setting the Dialing Mode Adjusting the Ringer Setting Auto TalkSetting Caller ID/CALL Waiting On the HandsetStoring Your Area Code Basic Operation Using the HandsetUsing Speakerphone Switching Between the Handset and Speakerphone Adjusting Speakerphone VolumeUsing Mute Putting a Call on HoldWay Conferencing Using Both the Handset and SpeakerphoneMaking a Conference Call Using the Phone with Extension Phones Using RedialUsing Flash Using Tone Services on a Pulse LineUsing a Headset Memory Dialing Storing a Number in MemoryHandset ∗ # & spaceEntering a Pause Editing or Deleting a Number in the Handset’s MemoryBase CHAIN-DIALING Service Numbers Testing Stored Emergency NumbersReviewing Memory Numbers Handset only Dialing a Memory NumberCaller ID Operation Handset Only Reviewing Caller ID RecordsCaller ID Messages FhlWj DWcADDING/DELETING the Area Code Dialing Numbers from a Caller ID RecordStoring a Caller ID Record to Memory Deleting Caller ID RecordsTroubleshooting Problem SuggestionCare Limited One-Year Warranty