PROBLEM-SOLVING
We do not expect you to have any problems with your TAD, but if you do, try these suggestions. If the TAD still doesn’t operate as you think it should, take the TAD to your local Radio Shack store for assistance.
Problem | Cause | Remedy | |
|
|
| |
|
|
| |
The TAD records a dial | The caller hung up without | Press 7 to play the | |
tone, siren, beeping, or | leaving a message or without | next message. | |
an operator’s voice | using the maximum time, and |
| |
instead of a caller’s | your local telephone com- |
| |
message. | pany does not send out CPC |
| |
| signals. |
| |
|
|
| |
| The phone line is not properly | Check all phone line | |
| connected. | connections. | |
|
|
| |
| The TAD is not plugged into | Make sure the AC | |
| the wall outlet. | adapter is properly | |
The TAD does not |
| connected to the | |
| TAD. | ||
answer calls. |
|
| |
There is not enough memory | Erase messages. | ||
| |||
| available to record a mes- |
| |
| sage. |
| |
|
|
| |
| The TAD is not set to answer | Press ON/OFF. | |
| calls. |
| |
|
|
| |
| You were too close to the TAD | ||
| or you spoke too loudly when | announcement, | |
| recording the announcement. | speaking in a normal | |
The outgoing |
| tone of voice about | |
| 12 inches from the | ||
announcement is dis- |
| TAD. | |
torted. |
|
| |
There was too much back- | |||
| |||
| ground noise in the room | announcement. | |
| when you recorded the |
| |
| announcement. |
| |
|
|
|
22