USING REMOTE COMMANDS
To use remote commands, you must enter the remote operation security code within 8 seconds after the TAD answers the call. After the TAD beeps once to verify you entered the code correctly, you can enter the number(s) for the function(s) you want the TAD to perform.
Press | Command | Function |
|
|
|
|
|
|
0 | Stop | Stops message play, message recording, and room |
|
| monitoring. |
|
|
|
1 | Play Outgoing Message | If an outgoing message is recorded, the TAD beeps |
|
| and says, “Play announcement,” then plays the out- |
|
| going message. After the message plays, the TAD |
|
| beeps once. If no outgoing message is recorded, |
|
| the TAD beeps, then announces, “No announce- |
|
| ment.” |
|
|
|
2 | Change Outgoing | Records a new outgoing message. When the TAD |
| Message | beeps and announces, “Record announcement,” |
|
| begin your new outgoing message. When you fin- |
|
| ish, press 0. The TAD beeps. |
|
|
|
3 | Room Monitor | Monitors the room where the TAD is located. The |
|
| TAD announces, “Room Monitor.” After 30 sec- |
|
| onds, the TAD beeps and monitoring stops. To stop |
|
| monitoring the room sooner, press 0. |
|
|
|
4 1 | Play All Messages in a | Plays all the recorded messages. Press 41 for Mail- |
4 2 | Specific Mailbox (To | box 1, 42 for Mailbox 2, 43 for Mailbox 3, or 44 for |
4 3 | see what commands | Mailbox 4. |
4 4 | you can use at this | When messages are recorded, the TAD beeps and |
| point, see the table on | announces, “Maibox __” and the number of mes- |
| Page 20) | sages, then plays them. If no message is recorded, |
|
| the TAD beeps and says, “Mailbox (number), no |
|
| message.” |
|
|
|
19