Operation, Setting the System to Answer Calls

1.Hold down REPEAT/ANNC/DAY. A1

flashes on the display, and the system sounds a tone.

2.Speak your message clearly into the microphone from about 10 inches away from the system.

3.Release REPEAT/ANNC/DAY when you finish your message. The system sounds a tone and

automatically plays back your recorded message. A1 appears on the display during playback.

OPERATION

SETTING THE SYSTEM TO ANSWER CALLS

To set the system to answer calls, press ON/OFF/STOP to turn on the system. The display lights.

When the system answers a call, it plays the outgoing message, then sounds a tone and begins recording.

The caller can leave a 1- to 5-minute long message, depending on which option you have chosen for incoming messages (see “Setting the Incoming Message Length” on Page 10). After the caller hangs up or is silent for more

Ô NOTES Ô

•The maximum length for an outgoing message is about 30 seconds. When it reaches the maximum outgoing message length, the system sounds a tone and plays back the message.

•If you record your own message and subsequently decide to use the prerecorded message, press

REPEAT/ANNC/ DAY to play the message you recorded. While it is playing, press DELETE to erase your message.

•To hear the outgoing message at any time, press

REPEAT/ANNC/ DAY. To stop the outgoing message before it ends, press ON/OFF/ STOP.

Operation