Radio Shack 43-3888 owner manual Operation

Page 16

Operation

Ô NOTES Ô

•If there are no messages, the system sounds two tones.

•Each message will be treated as a new message until you play back the entire message.

To listen to messages, press PLAY/ PAUSE/MIN. The system plays each new message and the sequence number appears. The system announces the day and time the message was recorded. After you play all the new messages, the display shows the total number of recorded messages, and the system automatically saves the messages and resets to answer calls.

To pause while listening to message, press PLAY/PAUSE/MIN. P appears on the display. The playback resumes when you press PLAY/PAUSE/MIN again, or the system returns to answer- ready mode after 7 seconds if you do not press PLAY/PAUSE/MIN again.

To replay the messages, press PLAY/ PAUSE/MIN.

During message playback, you can repeat the current message by pressing REPEAT/ANNC/DAY, repeat a previous message by holding down REPEAT/ANNC/DAY for over 1 second, or skip forward to the next message by pressing SKIP/TIME SET/CHECK.

To stop message playback at any time, press ON/OFF/STOP.

16

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Read this Before Installation FCC StatementFCC Statement FCC Wants YOU to Know Features Features Connecting AC Power Installing the Backup BatteryPreparation Connecting the System to a Phone Line Setting the DAY and Time Turning the System ON/ OFFSetting the Number of Rings Hour until you hear or see the correct hourSetting the Incoming Message Length Recording the Outgoing MessageSetting the System to Answer Calls OperationOperation Using ANNOUNCE-ONLY Recording a Memo Screening CallsRecording a TWO-WAY Phone Conversation Playing Incoming MESSAGES/MEMOS TWO-WAY Phone ConversationsOperation Deleting Messages Remote OperationSecurity Code Remote Commands Operating the System from a Remote LocationService and Repair CareRadioShack Corporation
Top Page Image Contents