Radio Shack 43-3888 owner manual Recording a Memo, Screening Calls

Page 14

Operation

Ô NOTES Ô

If you pick up the phone just as the system answers, the system might not stop playing the message. If this happens, press ON/OFF/STOP on the system or the hook switch on your phone to stop playing the message.

If the volume is set to the minimum level, during incoming calls the speaker will turn off and you will not hear incoming messages. However, the system will operate at the lowest volume whenever another key (REPEAT/ANNC/ DAY, MEMO/2 WAY/HOUR, PLAY/PAUSE/MIN,

SKIP/TIME SET/ CHECK) is pressed.

When the system is set for announce- only, you cannot set it to record incoming messages using the remote commands.

To turn off the announce-only feature so callers can leave messages, slide INCOMING MSG to either 1 or 5 MIN.

SCREENING CALLS

To screen calls, let the system answer, then listen to the caller’s message through the system’s speaker. To answer the call, pick up any phone connected to the same phone line as the system. The system stops recording and resets to answer the next call.

RECORDING A MEMO

A memo is a message up to 1 minute long that you record by speaking directly into the system, without calling in on the phone.

1.Hold down MEMO/2 WAY/HOUR. r1

flashes on the display, and the system sounds a tone.

2.Speak your message clearly into the microphone from about 10 inches away from the system.

14

Image 14
Contents Read this Before Installation FCC StatementFCC Statement FCC Wants YOU to Know Features Features Preparation Installing the Backup BatteryConnecting AC Power Connecting the System to a Phone Line Setting the DAY and Time Turning the System ON/ OFFSetting the Number of Rings Hour until you hear or see the correct hourSetting the Incoming Message Length Recording the Outgoing MessageSetting the System to Answer Calls OperationOperation Using ANNOUNCE-ONLY Recording a Memo Screening CallsRecording a TWO-WAY Phone Conversation Playing Incoming MESSAGES/MEMOS TWO-WAY Phone ConversationsOperation Security Code Remote OperationDeleting Messages Remote Commands Operating the System from a Remote LocationService and Repair CareRadioShack Corporation