Radio Shack 43-3888 owner manual Connecting the System to a Phone Line

Page 7

TEL LINE

standard AC outlet. The display lights and Cr appears.

The system initializes in about 20 seconds, then sounds 4 tones. 00 and

--alternately appear. If you did not

install a backup battery, Lo, 00, and --alternately appear.

CONNECTING THE SYSTEM TO A PHONE LINE

Plug the system’s attached phone line cord into the wall jack. Plug the modular phone line cord into the

system’s jack.

You must use compatible modular jacks that are compliant with Part 68 of FCC Rules.

Preparation

Ô NOTE Ô

The USOC number of the jack to be installed is RJ11C (or RJ11W for a wall plate jack).

Attached Phone Line Cord

Wall

Jack

DC 9V Jack

Modular Phone Line Cord

TEL LINE Jack

AC

Power Cord

7

Image 7

Contents FCC Statement Read this Before InstallationFCC Statement FCC Wants YOU to Know Features Features Connecting AC Power Installing the Backup BatteryPreparation Connecting the System to a Phone Line Turning the System ON/ OFF Setting the DAY and TimeHour until you hear or see the correct hour Setting the Number of RingsRecording the Outgoing Message Setting the Incoming Message LengthOperation Setting the System to Answer CallsOperation Using ANNOUNCE-ONLY Screening Calls Recording a MemoPlaying Incoming MESSAGES/MEMOS TWO-WAY Phone Conversations Recording a TWO-WAY Phone ConversationOperation Deleting Messages Remote OperationSecurity Code Operating the System from a Remote Location Remote CommandsCare Service and RepairRadioShack Corporation