ClearOne comm 900, 600 user manual Connecting VCRs and DVD players, Connecting PTZ cameras

Page 13

20

Connecting the RAV — Auxiliary Devices

Connecting VCRs and DVD players

You can record your audio/video conference or play audio using a playback device such as a VCR or DVD player.

Note: You can also connect a mono-signal device or a non-record/playback device to these line in/out connectors.

 

PLAYBACK / RECORD

L

L

IN

OUT

R

R

Figure 2.14. Connecting a Record/Playback device

To connect to record/playback

For recording, connect the Left and Right Audio Out on the RAV to the left and right audio in on the VCR or DVD player.

For playback, connect the Left and Right Audio In on the RAV to the left and right out on the VCR or DVD player.

Connecting PTZ cameras

The RAV system provides voice-tracking capabilities through VISCA control port connection to a Pan,Tilt, Zoom camera. Voice Tracking allows the camera to move to preset positions based on microphone activation. For instructions on programming the presets, see page 42.

CAMERA

CONTROL

Figure 2.15. Connecting a camera

To add a camera

Connect the camera to the Camera Control port on the mixer.

Note:The camera video out signal connects to a video codec.

Connecting the RAV— Auxiliary Devices

 

21

 

Connecting for serial control

You can connect a computer or a control device, such as an AMX or Crestron, to the RAV mixer through the serial control port. See the page 78 for a list of the serial commands.

To connect a computer serial port

Connect computer to Control port on the back of the mixer using a 9-pin serial cable.

RS-232

Figure 2.16. Connecting a computer serially

Connecting for USB control

You can also connect a computer to the RAV through the USB port.

To connect a computer through the USB port

Connect computer to the USB port on the front of the mixer using a USB cable.

Figure 2.17. Connecting a computer through the USB

Note:The USB drivers are installed when you install RAV-Ware.

Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760

Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760

Image 13
Contents Page Table of Contents Introduction RAV 600/900 Services and supportProduct returns UnpackingRF Radio Frequency Controller Product OverviewMixer Basic Room Design Microphone PodsBasic Room Design for RAV Speakers ceiling- or wall-mountInstallation Overview Network Information System Requirements for RAV-WareConnecting the RAV Basic Connections To set up audio conferencingAudio conferencing Attach the external antenna and turn it it is upright Auxiliary Devices Connecting video codecs, amplifiers and sound cardsTo connect to a video codec To connect to a sound cardConnecting PTZ cameras Connecting VCRs and DVD playersConnecting for serial control Connecting for USB controlTo connect to a digital phone Digital phonesRAV-Ware Software Configuration Introduction Install RAV-WareGetting started with RAV-Ware RAV-Ware overviewRAV-Ware files RAV-Ware connectionsCommunication Settings Configuring System SettingsNetwork Find Telephone Settings Regional SettingsMicrophones Customizing RAV ComponentsLoudspeakers Effects of using an external amplifierMixer Console Adjusting Line Input/Output settings Preconfigured video codecs, amplifiers and sound cardsLine Input and Output Adjusting Record/Playback settings Preconfigured record/playback devicesRecord and Playback Camera Controls Setting camera presetsDialer and Phonebook Usage PhonebookDialer System Checks Advanced FeaturesEvent Log Firmware upgrades Error MessagesDevice Toolbox Editor Using the RAV Managing Calls Using the ControllerAccessing the menu Using the Phonebook from the RF ControllerProgramming Phone Preferences Configuration Adjusting the SettingsTo perform RF radio test To select a frequencyTo enter flash duration To change LCD contrastTo check the RAV version To view the IP addressWeb Interface Overview Accessing the web interfaceDial To clear log To open event logTo download log Log Out System CheckTo open the system checks Appendix Troubleshooting MaintenanceAudio ControllerPinouts SpeakersCamera pinouts GeneralDimensions SpecificationsCommand structure Serial CommandsConventions Groups and channelsRAV serial commands Serial command error codesMeter type definitions Aarings Number of Rings to Auto Answer On AA Auto Answer Enable/ DisableAEC Acoustic Echo Canceller enable/ disable AD Auto Disconnect Enable/ DisableAecref Acoustic Echo Cancellation Reference Aconn Audible Connect / Disconnect IndicationCamctrlmode Camera Control Port Mode Batterylvl Battery LevelBaud Baud Rate Calldur Call DurationCampresetset Camera Preset Setup Campreset Camera PresetCamflow Camera Control Flow Control Cammove Move the CameraCamswitchlag Camera Switch Time Lag CAMPRESETSET2 Camera Preset SetupCamposition Camera Position Camtrack Camera TrackCleareffect Clear Effect Wide Band Telco Emulation Default Default The UnitClock Clock Set Country Country SelectionDial Dtmf Dialing Device Device Identification LabelDid Device ID Enetaddr Ethernet port IP address Enetgate Ethernet default Gateway addressEnetdhcp Ethernet Dhcp Selection Enetdnsa Ethernet DNS Server addressesGain Gain Adjustment Eqsel Equalization EnableEQ Equalization Flow Flow ControlHook Hook Flash Greport Gate ReportHookd Hook Flash Duration Label LabelLVL Level Lvlreporten Level Report EnableLvlreport Level Report Manufacturer Manufacturer Identification LabelNcsel Noise Cancellation Select Miccampreset Mic Camera PresetMtrx Matrix Routing Mute MutePhonebookadd Adds an Entry to the Phonebook Pbdial Dial a PB Entry by NamePhonebookcnt Queries the Number of Entries in the Phonebook Phonebookdel Deletes an Entry to the PhonebookRedial Dial the last number again Reset ResetRffreq RF Frequency Selection Ring Ring IndicationRingerlvl Audible Ring Level Silenceprst Silence Camera PresetRingersel Audible Ring Melody Selection Ringertest Audible Ring Melody TestSyschecks System Checks Stereomix Sets the Input to be a Stereo MixSysresult System Check Result 112Telcolvlctrl Telco TX Level Control Enable/ Disable TE Telco EnableVolume Volume Adjustment UID Unit IDCompliance Electrical Safety AdvisoryFCC Part 15/ICES-003 Compliance FCC Part 68 ComplianceEC Declaration of Conformity European ComplianceIndex
Related manuals
Manual 63 pages 47.95 Kb

600, 900 specifications

ClearOne Comm 900,600 is a cutting-edge communication platform designed to enhance audio and video conferencing experiences in both corporate and educational environments. With its advanced technology and user-friendly interface, ClearOne Comm 900,600 addresses the increasing demand for seamless collaboration in a hybrid work scenario.

One of the standout features of the ClearOne Comm 900,600 is its exceptional audio quality. Utilizing advanced beamforming microphone technology, the system captures sound from multiple directions while minimizing background noise. This ensures that every participant in a conference call is heard clearly, regardless of their position in the room. The system also supports high-definition audio processing, delivering crystal-clear sound that enhances the overall communication experience.

The ClearOne Comm 900,600 is equipped with state-of-the-art video capabilities as well, making it suitable for various applications. It supports high-definition video resolutions, enabling users to engage with their audience visually without compromising quality. The system is compatible with various video conferencing applications, ensuring flexibility for users who may prefer specific software solutions.

Another significant characteristic of the ClearOne Comm 900,600 is its scalability. Organizations can easily expand the system according to their needs. Whether it's a small meeting room or a large auditorium, the Comm 900,600 can be configured to accommodate various room sizes and setups. It provides multiple connection options, including USB and HDMI, making it easy to integrate with existing equipment.

Additionally, the ClearOne Comm 900,600 boasts a user-friendly interface that simplifies operation for all participants. Its intuitive controls ensure that even those unfamiliar with technology can navigate the system effortlessly. This focus on usability promotes a smooth and efficient meeting environment, which is essential in today’s fast-paced work culture.

Lastly, the ClearOne Comm 900,600 features robust security measures to protect sensitive data. It employs encryption protocols to safeguard communications while also adhering to industry standards for data protection. This ensures that organizations can conduct confidential discussions without concern for unauthorized access.

In conclusion, the ClearOne Comm 900,600 is an innovative solution for modern communication needs, offering advanced audio and video technologies, scalability, user-friendly operation, and strong security features. It is an essential tool for promoting effective collaboration in any organization.