GE 25982xx3, 00017670 manual Handset Sound Signals, Troubleshooting Guide, Telephone Solutions

Page 41

UNAVAILABLE	Indicates the handset is out of range. Or an additional handset
	is in use. Or there has been a base power failure, in which case
	you must place all handsets on the main base cradle for 20
	seconds to re-establish link with the base.
UNKNOWN NAME/	The incoming call is from an area not serviced by Caller ID or
CALLER/NUMBER	the information was not sent.
WAITING HANDSET	Prompt telling you to enter registration mode of handset.

REGISTRATION

Handset Sound Signals

Signal	Meaning
A long warbling tone (with ringer on)	Signals an incoming call
Three short beeps	Page signal
One short beep (every 7 seconds)	Low battery warning

Troubleshooting Guide

Telephone Solutions

No dial tone

•Check and repeat installation steps:

Ensure the base power cord is connected to a working outlet .

Ensure the telephone line cord is connected to the base and the wall jack.

•Connect another phone to the same jack; if there is still no dial tone, the problem might be your wiring or local service.

•The cordless handset may be out of range of the base. Move closer to the base.

•Ensure the battery is properly charged (16 hours).

•Ensure the battery pack installed correctly.

•Did the handset beep when you pressed the TALK/CALL BACK or SPEAKER button? The battery may need to be charged.

•Place handset in charge cradle for at least 20 seconds.

Dial tone is OK, but can’t dial out

•Make sure the TONE/PULSE setting on the base is set to the type of phone service you are subscribed to.

41

Image 41

Contents Model Notification to the Local Telephone Company Equipment Approval InformationHearing Aid Compatibility HAC Interference InformationLicensing FCC RF Radiation Exposure StatementTable of Contents Display Messages Telephone Jack Requirements Introduction Before You BeginDigital Security System InstallationImportant Installation Guidelines Base Layout Handset and Charge Cradle LayoutInstalling the Handset Battery Installing the PhoneConnecting the Telephone Line Installing the PhoneConnecting the AC Electrical Power Connecting the Corded Handset Answering System Set UpVoice Instructions Attaching the Pedestal BracketRecording the Outgoing Announcement Answering System OperationReviewing Announcement Leaving a MessageMessage Playback from Base Unit Screening Calls from the BaseScreening Calls from the Handset Leaving a Memo Erasing MessagesLanguage Telephone Set UpRings to Answer Handset NameDisplay Contrast Base Ringer Level Security CodeVIP Ring Tone Handset Ringer ON/OFFRinger Tone Local Area Code Setting Day/TimeRegistration Link Cordless Handset Tone/Pulse DialingTransfer ON/OFF Answering a Call Default SettingBasic Operation Making a Call Call TimerManual Channel Selection Auto StandbyFlash Handset Ringer on/off ShortcutDo Not Disturb Transferring Call from Base to Cordless Handset Call TransferLast Number Redial Paging the Cordless Handset HoldAnswering System VolumeMute Base Unit Speakerphone Operation Switching Between Speakerphone and HandsetReceiving a Call with Speakerphone Making a Call with SpeakerphoneMemory Switching Between the Speakerphone and Handset EarpieceCordless Handset Speakerphone Operation Storing a Name and Number in MemoryReviewing, Changing or Deleting Stored Names/Numbers Storing a Redial NumberInserting a Pause in the Dialing Sequence Dialing a Stored Number Number For Chain Dialing from MemoryReceiving CID Records Caller ID CIDCall Waiting Caller ID Reviewing Call Records Storing CID Records In CID MemoryDialing a Caller ID Number Storing CID Records in Internal MemoryDeleting All Caller ID Records Deleting the Current Caller ID RecordCaller ID Errors Remote AccessUsing the Handset Answering System IndicatorMemory Full Accessing the Answering System from Another LocationChanging the Security Code Changing the BatteryBattery Safety Precautions Connecting the Belt Clip Connecting an Optional Headset to the HandsetHeadset and Belt Clip Operation Display MessagesEND of List Telephone Solutions Handset Sound SignalsTroubleshooting Guide Page Causes of Poor Reception Caller ID SolutionsBattery Solutions General Product Care ServiceIndex Reviewing Changing or Deleting Stored Names/Numbers For how long after your purchase Limited WarrantyLimitation of Warranty Accessory Information