PHONEBOOK STORAGE PROCESS
TIP
All four steps must be entered to complete the storage process. The display will read DONE and you will hear a beep.
TIPS
When the memory is full, you will hear a beep and “Memory Full” appears. You cannot store any more names and numbers.
STEP 1: STORING NAMES
1)From Standby (the Remote charged and the Talk Button not pressed — display is blank), press the 
/tSPEED button.
2)Press the SELECT/CH 
button to begin the
storage process. “Store/Edit Name” appears.
3)Enter the name (up to 16 characters) by using the number keypad.
•See the “Steps for entering names and special characters” (see the previous table).
•Use s and t to move the cursor to the desired location.
•Use DELETE to delete characters as needed.
•Press and hold DELETE to delete all the characters.
•If a name is not required, skip step 3 and go to step 5.
4)Press SELECT/CH to store the name, then “Store/Edit No.” appears ready for the next step.
STEP 2: STORING PHONE NUMBERS
5) From the “Store/Edit No.”
display. press the
number keypad to enter the phone number (up to 20 digits).
6) Press SELECT/CH to store the number.
STEP 3: DISTINCTIVE RINGS
7) “Distinctive Ring” appears. Then press ▲ or ▼ to
move the pointer to hear and choose one of the distinctive ring options.
8) Press SELECT/CH to store the distinctive ring.
STEP 4: SPEED DIAL
9) “Speed Dial” 
appears. Then 
press ▲ or ▼ to
move the pointer to select the speed dial location (10 locations: SPD1– SPD0).
10)Press SELECT/CH to store.
You will hear a confirmation tone and “Done!” appears on the display.
TIPS
The pause key |
|
counts as one |
|
digit. Pressing | P |
PAUSE/REDIAL | |
not to store a | HONEBOOK |
more than once |
|
increases the length of pause between numbers.
If you choose
“Distinctive Ring”, simply select the “No Selectn” option.
If you select a speed dial location where a number is already stored, the new number will replace the old number, and the old number will remain in the Phonebook, but
18
This completes your entry into the Phonebook. Now in the standby mode when you press the 
/tSPEED button, the Phonebook will show another entry.
no longer be on speed dial.
19