TONE DIALING SWITCH-OVER
SELECTING A DIFFERENT CHANNEL
TIP
The tone feature only applies when the dial mode is set to pulse.
A tone number can be stored in
Some telephone
companies use equipment that require pulse dialing (sometimes referred
to as rotary dialing). If you need to enter tone dialing digits,
you can
If you encounter interference while using your phone, you can manually change the phone’s channel for clear operation. This function works only when the phone is in use.
Press SELECT/CH. “Scanning” appears on the display, indicating the phone is changing to another channel.
BASICS
amemory location. This is referred to as Chain Dialing. (See page 25.)
account number after you have called your bank.
Initially make your call with the pulse dialing mode. Once your call connects, press ✱/TONE. Enter the desired number. These digits will be sent as tone dialing. Once the call ends, the tone mode is canceled and pulse dialing mode resumes.
FIND REMOTE
To locate the remote, press PAGE on the base. The remote beeps for 60 seconds, and “Paging”
TIP
If the remote battery is completely drained, the
TRAVELING OUT-OF-RANGE
During a call, as you begin to move your remote too far from your base unit, static increases. If you pass the range limits of the base unit, your call will terminate within 30 seconds.
appears on the display.
Paging is canceled when pressing any key on the remote or PAGE on the base. Additionally, if you receive an incoming call, PAGE is canceled.
remote will not beep when paging.
12
13