Talkswitch TS-600 manual Adjusting the Display Contrast, Adjusting the Handset Receiver Volume

Page 11

T S - 6 0 0 U S E R G U I D E

ADJUSTING THE DISPLAY CONTRAST

The display can be adjusted to suit the light level of your room and your viewing preference. To make the contrast of the display lighter or darker, press the button to the right of the screen until the desired contrast is reached.

ADJUSTING THE HANDSET RECEIVER VOLUME

If you need to adjust the handset receiver volume:

1.Lift the handset and listen to the dial tone.

2.Press the right side of the VO LU M E button to increase the receiver volume.

3.Press the left side of the VO LU M E button to decrease the receiver volume.

4.Replace the handset when the desired receiver volume is reached.

ADJUSTING THE HEADSET RECEIVER VOLUME

If you wish to use a headset with this telephone, we recommend a headset with a built-in amplifier for the microphone. An amplifier for adjusting headset receiver volume is built into this telephone. If you need to adjust the headset receiver volume:

1.Press the headset button and listen to the dial tone.

2.Press the right side of the VO LU M E button to increase the receiver volume.

3.Press the left side of the VO LU M E button to decrease the receiver volume.

4.Press the headset button or the G O O D BY E button when the desired receiver volume is reached.

Note: The headset and handset volumes are tied together. Changing the headset volume will also change the handset volume.

ADJUSTING SPEAKERPHONE RECEIVER VOLUME

If you need to adjust the speakerphone receiver volume:

1.Press the S P E A K E R button and listen to the dial tone.

2.Press the right side of the VO LU M E button to increase the receiver volume.

3.Press the left side of the VO LU M E button to decrease the receiver volume.

4.Press the S P E A K E R button or the G O O D BY E button when the desired receiver volume is reached.

W W W.T A L K S W I T C H . C O M

7

Image 11
Contents Talkswitch TS-600 Telephone TalkSwitch is a division of Centrepoint Technologies Inc Table of Contents Page Introduction Installing Your PhoneImportant Safety Instructions W.T a L K S W I T C H . C O M Connecting power through cord adapter Part ChecklistInstallation Connecting the handsetWall Mounting Connecting power directly from the AC adapterConfigure Area Codes Setting UP Your TS-600 PhoneSelecting ring tone Configure the Outside Line Access CodeExtensions with Direct Line Access Adjusting the display angleAdjusting Speakerphone Receiver Volume Adjusting the Display ContrastAdjusting the Handset Receiver Volume Adjusting the Headset Receiver VolumeOverview of the TS-600 Phone Using Your PhoneKEY Label Usage Making a Call Phone DisplayMenus and Softkeys Receiving Calls Redialing CallsTransferring a Call Hanging UP a CallPutting a Call on Hold Call Waiting and Queued CallsPicking UP a Call Conferencing CallsTo retrieve a call that has been parked OVERHEAD, Intercom and Group Paging Check Voicemails Ring Once FeatureDo not Disturb Send a Call to VoicemailCalling Back a Number from the Call LOG Accessing the Call LOGViewing the Caller ID List Searching Telephone Numbers in the Directory Using ONE-TOUCH Speed DialsUsing the Phone Directory Deleting a Call from the Call LOGWhile reviewing the call Log Deleting Entries in the DirectoryProgramming a NEW Phone Number Saving a CALLER’S Name and Number Resetting Your TELEPHONE’S Programming Maintenance InformationTroubleshooting No Dial Tone Reset to Factory DefaultsBlank Screen Phone DOESN’T RingCAN’T Receive ON-HOOK Intercom Calls Problems DialingHandset DOESN’T Work Message Waiting Count does not WorkLimited Warranty For Products Purchased in the U.S. or Canada Repair Instructions FCC Registration and Repair InformationConnection and USE with the Nationwide Telephone Network Interference Information Part 15 of FCC Rules