Talkswitch TS-600 manual Connecting power directly from the AC adapter, Wall Mounting

Page 8

T S - 6 0 0 U S E R G U I D E

Connecting power directly from the AC adapter

Alternatively, you can power this phone by directly connecting the AC power adapter to the phone.

1.Remove the rubber cap covering the DC12V plug behind the phone. It is located beside the TEL LINE jack.

2.Connect the AC adapter plug to the DC 12V jack of the telephone.

3.After installation, lift the telephone’s handset and listen for the dial tone. If there is no dial tone, check to make sure all cords are firmly plugged into their jacks.

WALL MOUNTING

1.Turn the phone over so that you are looking at the bottom of the phone. Insert tabs at the narrow end of the wall-mount bracket into the holes at the rear of the phone bottom. Press and latch the tabs at the thicker end of the wall bracket into holes at the front end of phone. The bracket has two round plastic holes that can be used to hang your phone on the wallplate on your wall.

Note: If you do not wish to mount your phone on the wall, the Wall Mount Bracket can be reversed to raise the angle of the phone’s display when sitting on a table or desk.

4	W W W.T A L K S W I T C H . C O M

Image 8

Contents Talkswitch TS-600 Telephone TalkSwitch is a division of Centrepoint Technologies Inc Table of Contents Page Introduction Installing Your PhoneImportant Safety Instructions W.T a L K S W I T C H . C O M Part Checklist InstallationConnecting the handset Connecting power through cord adapterConnecting power directly from the AC adapter Wall MountingSetting UP Your TS-600 Phone Configure Area CodesConfigure the Outside Line Access Code Extensions with Direct Line AccessAdjusting the display angle Selecting ring toneAdjusting the Display Contrast Adjusting the Handset Receiver VolumeAdjusting the Headset Receiver Volume Adjusting Speakerphone Receiver VolumeUsing Your Phone Overview of the TS-600 PhoneKEY Label Usage Making a Call Phone DisplayMenus and Softkeys Redialing Calls Receiving CallsHanging UP a Call Putting a Call on HoldCall Waiting and Queued Calls Transferring a CallPicking UP a Call Conferencing CallsTo retrieve a call that has been parked OVERHEAD, Intercom and Group Paging Ring Once Feature Do not DisturbSend a Call to Voicemail Check VoicemailsCalling Back a Number from the Call LOG Accessing the Call LOGViewing the Caller ID List Using ONE-TOUCH Speed Dials Using the Phone DirectoryDeleting a Call from the Call LOG Searching Telephone Numbers in the DirectoryWhile reviewing the call Log Deleting Entries in the DirectoryProgramming a NEW Phone Number Saving a CALLER’S Name and Number Resetting Your TELEPHONE’S Programming Maintenance InformationTroubleshooting Reset to Factory Defaults Blank ScreenPhone DOESN’T Ring No Dial ToneProblems Dialing Handset DOESN’T WorkMessage Waiting Count does not Work CAN’T Receive ON-HOOK Intercom CallsLimited Warranty For Products Purchased in the U.S. or Canada Repair Instructions FCC Registration and Repair InformationConnection and USE with the Nationwide Telephone Network Interference Information Part 15 of FCC Rules