Talkswitch TS-600 manual Redialing Calls, Receiving Calls

Page 15

T S - 6 0 0 U S E R G U I D E

Call log — Dial from the call log. See the Call Log section for details on page 16.

Directory — Dial from the Phone Directory. See the Phone Directory section for details on page 17.

One-touch speed dial — Press the desired “One Touch” speed dial key to call a pre-programmed number.

Outside line access code is dialed automatically before any number with 7 or more digits stored in the call log, directory, or memory buttons.

If you use the telephone keypad to dial a number, please dial the outside line access code before the number.

You can switch a call between the handset, speakerphone or headset during the call by either lifting the handset, pressing the speaker or headset buttons.

REDIALING CALLS

1. When you press the R E D I A L button, a list of previously dialed numbers is displayed. The most recently dialed number is displayed on the top of list.

2.Press the S button and the T button to move the highlighted line up and down, respectively. Press the D I A L / E N T E R button when the desired number is highlighted.

RECEIVING CALLS

 

 

 

When receiving calls, your phone will ring and the

 

 

12/09

03:00 PM

display will show caller identity information if

613-725-2980

you are subscribed to Caller ID service.

 

 

John Smith

To answer an incoming call,

 

Answer

Ignore

Lift the handset, or

 

 

 

 

 

 

Press the S P E A K E R button or A N S W E R

softkey, to answer the call in

speaker phone mode, or

 

 

 

Press to answer the call in headset mode.

You can mute the ringing for the incoming call by pressing the I G N O R E softkey.

Ringing volume can be adjusted or turned off by using the V O LU M E button while the phone is idle or ringing.

W W W.T A L K S W I T C H . C O M

1 1

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Talkswitch TS-600 Telephone TalkSwitch is a division of Centrepoint Technologies Inc Table of Contents Page Installing Your Phone Important Safety InstructionsIntroduction W.T a L K S W I T C H . C O M Connecting power through cord adapter Part ChecklistInstallation Connecting the handsetWall Mounting Connecting power directly from the AC adapterConfigure Area Codes Setting UP Your TS-600 PhoneSelecting ring tone Configure the Outside Line Access CodeExtensions with Direct Line Access Adjusting the display angleAdjusting Speakerphone Receiver Volume Adjusting the Display ContrastAdjusting the Handset Receiver Volume Adjusting the Headset Receiver VolumeOverview of the TS-600 Phone Using Your PhoneKEY Label Usage Phone Display Menus and SoftkeysMaking a Call Receiving Calls Redialing CallsTransferring a Call Hanging UP a CallPutting a Call on Hold Call Waiting and Queued CallsConferencing Calls To retrieve a call that has been parkedPicking UP a Call OVERHEAD, Intercom and Group Paging Check Voicemails Ring Once FeatureDo not Disturb Send a Call to VoicemailAccessing the Call LOG Viewing the Caller ID ListCalling Back a Number from the Call LOG Searching Telephone Numbers in the Directory Using ONE-TOUCH Speed DialsUsing the Phone Directory Deleting a Call from the Call LOGDeleting Entries in the Directory Programming a NEW Phone NumberWhile reviewing the call Log Saving a CALLER’S Name and Number Maintenance Information TroubleshootingResetting Your TELEPHONE’S Programming No Dial Tone Reset to Factory DefaultsBlank Screen Phone DOESN’T RingCAN’T Receive ON-HOOK Intercom Calls Problems DialingHandset DOESN’T Work Message Waiting Count does not WorkLimited Warranty For Products Purchased in the U.S. or Canada FCC Registration and Repair Information Connection and USE with the Nationwide Telephone NetworkRepair Instructions Interference Information Part 15 of FCC Rules
Top Page Image Contents