Curtis TC972 owner manual Receiving Calls with the Handset on the Base Unit, Storing Numbers

TC972 english.qxd 4/13/2004 10:58 AM Page 12

Getting Started

Receiving Calls with the Handset on the Base Unit

1.When the phone rings, lift the Handset. The IN USE LED indicator will light up.

NOTE: The Handset RINGER ON/OFF switch must be in the “ON” position for ringer to operate.

2.Start your conversation.

3.To end your conversation, either press the TALK button or place the Handset on the Base Unit. If you place the Handset on the Base Unit CHARGE CRADLE, you activate the automatic standby feature.

Storing Numbers

1.Be sure the Base Unit IN USE LED indicator is off and the Handset is in standby mode.

2.Press the MEMO button.

3.Dial the number you want to store.

4.Press the MEMO button again.

5.Dial the Keypad 0~9 button where you want to store that number. You will hear one confirmation “beep.”

6.Repeat steps 1 through 5 to store other telephone numbers.

EXAMPLE : To store the number 115-1968 under the Keypad 1 button: 1 - Press the MEMO button. 4 - Press the keypad 1 button.

2 - Dial 115-1968.5 - You have stored 115-1968 under keypad 1 button. 3 - Press the MEMO button again.

A total of 10 telephone numbers can be programmed in memory.

IMPORTANT: The maximum number of digits that can be stored for any phone number is 16 in PULSE or TONE mode. The maximum number of digits for mixed (TONE and PULSE in combination) dialing is 15. If you are using a switchboard system to access an outside line (such as an 8 or 9), press the PAUSE button to store a Pause.

11