Resetting the Handset without the Base
If your original base is not available for some reason (for example, it is lost or somehow incapacitated), you can still reset the handset and use it with another base.
) Press and hold [
] and [#] for more than 5 seconds.
2)Move the cursor to select the BASE UNAVAILABLE and then press the OK soft key. BASE UNAVAILABLE appears.
3)Move the cursor to select YES, and then press the OK soft key. ARE YOU SURE? appears.
Base Unavailable
Yes
No
BACK DELETE OK
4)Move the cursor to select YES, and then press the OK soft key. .
You will hear a confirmation tone. The handset will delete its own base information without trying to contact the base. When the base information is deleted, the handset displays MODELS VARY! PLACE HANDSET ON THE BASE FOR REGISTRATION OR REFER TO OWNER’S MANUAL. Register the handset to the new base (see page 23).
Changing the Digital Security Code
The digital security code is an identification code used to connect the handset and the base. Your unit ships from the manufacturer with a preset security code. Resetting this code is not normally necessary. In the rare situation that you suspect another cordless telephone is using the same security code or if you are instructed to change this code by a manufacturer’s Call Center Representative, you can change the code by:
.Perform “Resetting the Handset” for all of your handsets.
2.
Traveling Out of Range
During a call, if you move your handset too far away from your base, noise may increase. If you pass the range limits of the base, you will hear a beep and see OUT OF RANGE on the display, and then the handset returns to standby.
52