EXPANDING YOUR DECT SYSTEM
Adding new handset
Your HM base can register up to 5 HM handsets or any GAP compatible handsets. (Note: However, the HM features of real time clock, VIP and other special features of NTLD1300 may not be available when using different GAP DECT Phone of different brand).
The handset number is displayed at the left side corner in the handset LCD. It is labeled as 1, 2, 3, 4, or 5. Your original handset is the 1st to be registered to your base, so, it is labeled as 1.
To register another HM handset to your base, you should know your NTLD1300 system PIN code. This is a numerical digit code (maximum of 8 digits). It was preset to 0000. You can changed this PIN code if you like that your HM cordless phone system will not access by other person. See To Change PIN Code in the following part ADVANCE FEATURES.
You cannot register another handset to your HM if you do not know the PIN code.
Registering a new handset
This function allows you to register a handset with a base station. Up to 5 HM handsets can be registered to a Sapphire base station and each HM handset can be registered to up to 4 HM base units. If your HM base already has 5 handsets, and you wish to change one of them, you must firstly delete a handset, then register the new handset.
Note: Initially this function is not required since the handset supplied in this system is already registered to the base supplied. However, this procedure is required if you add a further handset to the system. It would be required for the existing handset if you inadvertently
Note: Before beginning of a registration procedure, ensure the new handset is fully charged, and position the base unit and new handset in front of you.
On the base:
Press and hold the PAGE button until the base emit two beeps and the In Use LED will flash. This means that the base is put into registration mode and it is now ready to be associated with a new handset, during 180 seconds after pressing the button only.
On the handset:
1.Press OK/Menu button. PHONEBOOK is displayed.
2.Use DOWN button to scroll to REGISTRATION.
3.Press OK/Menu button. REGISTER is displayed.
4.Press OK/Menu button. BS (base) 1 to 4 is displayed. The blinking number indicates a FREE BASE which means you can register your HM handset to any of these free base. If number 2,3 and 4 are blinking, press 2 on the keypad to register this handset to base number 2. When you entered the base number for this handset, then the handset will display PIN?.
5.Use numeric keys to enter PIN number of the base unit (default is 0000). Press OK/Menu to confirm. SEARCH2 will be displayed. (SEARCH 2 means that the handset is looking for the base number 2 where you intend your NTLD1300 handset to register.
-22 -