Marquis 2802CID manual Installation Is Completed, Connecting The Handset Cord

Page 14

INSTALLATION

Installation Is Completed

The installation diagram shown, is the final installation configuration for the 2802CID telephone. If the installation is correct, the following information will be displayed on the LCD (after off-hook):

12/01 P M 12:00

12 - 01 12 - 00

DATE TIME

Installation Diagram

Connecting The Handset Cord

A 10’ modular coil handset cord is provided. To install, simply plug one end of the handset cord into the modular jack on the handset. The remaining end of the handset cord plugs into the jack labeled “Handset” located on the left side of the 2802CID base unit.

14

Image 14

Contents User Guide Introduction Compliance and Safety Contents Features Controls Definition of Controls Right Side Left Side Bottom Definition of Controls Parts Check List Installation Wall Mounting Your 2802CIDConnecting The Power Pack Power Input/Output JacksPower Pack Line Connection Power Pack Phone ConnectionInstallation Is Completed Connecting The Handset CordT t e r y P r e p a r a t i o n To Remove the Insulator StripMessage Waiting Selector Switch SettingsTone/Pulse Dialing Selector Line Voltage SelectorsStore Key Guest Service Keys Speed Dial MemoryProgramming Guest Service Directory Speed Dial Memory Guest Service Directory Pre-SetsProgramming Procedure To Verify Programming TouchLite Feature Programming The TouchLiteCaller Identification Caller ID Operation Displaying Caller Identification Caller ID InformationDisplaying The Date & Time Line Status Indicators Line Selection Keys Placing a Call Using The Handset Placing a Call Using Speakerphone Using The Hold Feature Using The Conference Feature Using The Mute Feature Using The Master Volume Control Service Warranty Statement of Limited Warranty252-03590 2802CID Revision May 1