Marquis 2802CID manual Switch Settings, Tone/Pulse Dialing Selector, Message Waiting Selector

Page 16

SWITCH SETTINGS

There are installer selectable switches located on the bottom of the 2802CID base unit. These switches are hidden behind a plastic cover for security. To locate, remove the plastic covers using a sharp pointer or paper clip as shown.

Tone/Pulse Dialing Selector

The 2802CID has the option to out -dial either in “touch-tone” or electronic rotary pulse mode. Simply slide the switch to the desired position associated to your dialing service. Note: the 2802CID is factory preset to the “Tone” mode setting.

Message Waiting Selector

The 2802CID can support 90VDC neon or low - voltage LED (FSK compatible) message waiting systems. Simply slide the switch to the desired position that is compatible with your PBX messaging system. Note: the 2802CID is factory preset to the “Neon” setting.

Line Voltage Selectors

The 2802CID is designed to operate behind PBX telephone systems rated between 24 volts and 48 volts. There are line voltage selector switches that must be set according to the PBX system rating that the 2802CID will be installed. There are two (2) switches, the first for Line 1 and the other for Line 2. Each switch has three (3) setting options. They are: “24V/48V/ OFF”. Set the switches by simply sliding to the appropriate setting. The ”OFF” setting is used to turn off the line if a line appearance is not wired to the telephone. Note: the 2802CID is factory set to the “24V” setting.

16

Page 15 Page 17
Image 16
Page 15 Page 17
Contents User Guide Introduction Compliance and Safety Contents Features Controls Definition of Controls Right Side Left Side Bottom Definition of Controls Parts Check List Installation Wall Mounting Your 2802CIDConnecting The Power Pack Power Input/Output JacksPower Pack Line Connection Power Pack Phone ConnectionInstallation Is Completed Connecting The Handset CordT t e r y P r e p a r a t i o n To Remove the Insulator StripSwitch Settings Tone/Pulse Dialing SelectorMessage Waiting Selector Line Voltage SelectorsProgramming Guest Service Keys Speed Dial MemoryStore Key Guest Service Directory Speed Dial Memory Guest Service Directory Pre-SetsProgramming Procedure To Verify Programming TouchLite Feature Programming The TouchLiteCaller Identification Caller ID Operation Displaying Caller Identification Caller ID InformationDisplaying The Date & Time Line Status Indicators Line Selection Keys Placing a Call Using The Handset Placing a Call Using Speakerphone Using The Hold Feature Using The Conference Feature Using The Mute Feature Using The Master Volume Control Service Warranty Statement of Limited Warranty252-03590 2802CID Revision May 1
Top Page Image Contents