Shiro SD8141 manual Alarm setting, PIN code changing, Dialing mode setting, Reset to default value

Alarm setting

SD8141 is equipped with daily alarm. The alarm can be set daily but the alarm time will reflect the time that was set previously. The alarm duration is 30 seconds. Press any handset key to stop alarm. To set, follow as below:

-enter sub-menu "HANDSET" which is in the main menu and search for "ALARM". Enter

this sub-menu and select "ALARM TIME". Press and set hours. Press key. Set

minutes and press key.

Press either RD or and select "SET ALARM ". Set "YES " or "NO". Press to

confirm.

Repeat the last step to enable alarm every day.

PIN code changing

When you perform advanced setting or subscribe to a new handset, a PIN code is used for the security of Tower. The default PIN code is "0000 ". To set new PIN code, follow as

below:

- enter sub- menu "BASE " which is in the main menu and search for "ADVANCED ". Press

	, LCD screen will display "PIN ". Input old PIN (0000 default) and press				. Look for
"PIN CODE " and press				. LCD screen will display "NEW PIN", input new PIN (maximum
8 digit) and press			key. LCD screen will display “REPEAT", input new PIN again and
press		to confirm.

Dialing mode setting

Most of the public telephone centrals use tone (DTMF) dialling which is much more faster than Pulse dialling. However if your telephone line is connected to an old one,

you will need to set Pulse dialling to dial outgoing numbers. To set, follow as below:

- enter sub-menu "BASE" which is in the main menu and search for "ADVANCED". Press

	, LCD screen will display "PIN ”. Input PIN code (0000 default) and press		. Look
for "DIAL MODE" and press		. Select between "TONE" and "PULSE" and press		to
confirm.

Reset to default value

In case if you need to revert to default setting, reset as follows. This will erase all

memories and Tower will come back to default setting.
- enter sub-menu "BASE" which is in the main menu and search for "ADVANCED". Press
	, and LCD screen will display "PIN ". Input PIN code (0000 default) and press			.
Look for "DEFAULT" and press			. LCD screen will display "CONFIRM? ". Press	to
confirm and it will return to the default setting.
NOTE: With the reset, the name of the handset does not return to the default name.
NOTE: With the reset, the		routable and special prefix are deleted, see "LCR "

paragraph to input the default prefix.

14