AC/DC adaptor installation
Connect the plug of the adaptor to the power jack
of the base set located at the back, and connect it to the 220V socket.
Phone line connection
Connect the plug of the telephone line cord to the jack of base set 
located at the back, and connect it the line socket.
Battery installation
1- Remove the battery door;
2- Insert the batteries into the compartment;
3 - Close battery door.
IMPORTANT: The
Battery charging
Put the handset onto the cradle. Charge at least 10 hours when the battery is totally discharged. The light indicator will light up to show that the handset is in charging mode. When completely charged, this light indicator will remain on.
Coverage range
The coverage area could be affected from manifold situations. The indication of 300m outdoor and 50m indoor serves as a guide which is obtainable only in a optimal conditions of propagation of the signal. However for a better coverage it is advisable to install the base set in a central position of the building within where the cordless phone be used.
Precautions
1)Read this manual before using this phone.
2)Avoid direct exposure to solar rays and/ or fronts of heat, as well as to avoid the installation in damps places and/ or dusty.
3)Do not support objects on the cables and/ or on the phone.
4)Do not use adaptor and/ or batteries diverged from those specified on this instructions manual or however from those in endowment.
5)In case of storms, disconnect the phone from power and phone lines.
6)Clean by using a slightly dampened cloth. Do not use alcohol, solvents, abrasives, etc.
7)Do not effect reparations alone. Tampering and/ or uses not in conformity with those described on the instructions manual will render the warranty void.
8)Shiro Corporation declines any responsibility in case of improper uses or manipulations not conform with the instructions as described in this manual.
7