Shiro SD8101 user manual Handset and base unit, Phonebook button

Page 4

User Manual

The handset and base unit

MENU button

Press to enter menu mode and enter sub-menu. Press the key

" " to lock or unlock the keypad.

PHONEBOOK button

In standby mode, press to enter phonebook menu

Press to confirm selection.

You need the button if you phone is Connected to a PABX.

CALL button

Press to begin, answer and end a telephone call.

UP and DOWN button

In standby mode, press to show phonebook list

Press during programming to move through the menu.

Press during a call to change the volume in the earpiece.

SPEAKERPHONE button

Press to turn the speakerphone ON/OFF

Before you can use the handset to make calls for the first time, you will need to fit and fully charge the battery for 15 hours.

CLEAR button

Press and hold (2-3 seconds) to switch the handset on and off

Press during programming to go back to the previous option, or to clear digits one by one from the display. Press during a call to mute the microphone

IN USE light

The IN USE light comes on when you have a connection to the telephone line.

CHARGE light

The CHARGE light comes on when the handset's batteries are being charged.

HANDSET LOCATOR button

Press this to make the handset ring,

if you cannot remember where you put it. Press it again to stop the handset ringing.

INT button

Press to make an intercom call (if you have more than one handset)

3

Image 4
Contents SD8101 Contents What the symbols mean Handset and base unit Phonebook buttonSetting up your telephone Radio signals between handset and base unitConnection and conditions for use How many phones can you connect?Whats in this pack Installation Choose a suitable site for the base unitCharger pod does not have a connection to the telephone line Important safety information Warranty Information Making and answering calls Phone Book Muting the mouthpieceTo store a number into phonebook To clear a number from phonebookCall Logs To modify change a number in phonebookTo clear all numbers from phonebook To check call recordsHandset Setting Ringer Volume EXTRinger Volume INT Key tone on and offRinger Melody INT Ringer Melody EXTYour handset name Auto Talk Display languageTo Lock /Unlock the keypad Base Setting Default PIN No To set call barring numberTo delete call barring number Base MelodyBase Volume Least call route LCR function OptionalPabx function To reset base To Set Dial ModeTo enter Baby call mode To exit Baby call modeBaby Call To set the Baby Call numberHandset registration Resetting the systemTo register a handset Intercom and transfer To make an intercom callTo end an intercom call To transfer a callTroubleshooting Handset does not ringHandset’s battery are running low within an hour or two Electrical power Technical DetailsDeclaration of Conformity