This equipmentcomplies with Parts 15 and 68 of the FederalCommunications Commission(FCC) rulesfor the United States. Italsocomplieswith regulations
A label is located on the underside of the base unitcontaining eitherthe FCC registration number and Ringer Equivalence Number (REN) or the IC registration number and Load Number (LN). You must, upon request, provide this informationto your localtelephone company.
This equipment is compatible with inductively coupled hearing aids.
Should you experience trouble with this telephone equipment, please contact:
In the United States:
VTECH COMMUNICATIONS
VTECH ELECTRONICS
for repaidwarranty information. The telephone company may ask you to disconnectthis equipmentfromthe line network until the problem has been corrected.
Your VTech900iis designedtooperate at the maximum power allowed by the FCC and IC. This meansyour handset and base unit can communicate only over a certain distance - which will depend on the location of the base unit and handset, weather, and the construction and layout of your home or office.
If you move the handset out of range during a phone conversation, you will hear an 'Outof Range'tone to tell you to movecloserto the base. Ifyou do not move within range within 30 seconds the call is automatically disconnected.
If you move out of range when the handset is in standby mode, it will give an 'Outof Range' toneto tell you that the handset will not be able to receive or place calls. You may terminate the 'Outof Range' toneby pressing any number key on the handset.
FCC Part 15
this unit not expressly approved by the party responsibleforcompliance'scould void the user's authorityto operate the
The equipment has been tested and found to comply with part 15of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipmentgenerates, uses and can radiate radio frequency energy and, if not installedand used in accordance with the instructions, may cause harmful interference to radio communications. However,there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try and correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet or on a circuit different from that to which, the receiver is connected.
-Consult the dealer or an experiencedradiorrvtechnicianfor help.
FCC Part 68
The FCC requires that you connect your cordless telephone to the nationwide telephone network through a modular telephone jack (USOC RJ11C or RJ11W).
Your telephone company may discontinue your service if your equipment causes harm to the telephone network. They will notifyyou inadvanceofdisconnection,if possible. Duringnotification,you will be informed of your right to file a complaint with the FCC.
Occasionally,your telephonecompany may make changes in its facilities, equipment, operation, or procedures that could affect the operation of your equipment. If so, you will be given advance notice of the change to give you an opportunity to maintain uninterrupted service.
The base unit contains no user serviceable parts. The handset contains a user replaceable battery pack.
If it is determined that your telephone equipment is malfunctioning, the FCC requiresthat it not be usedandthat it be unplugged from the modular jack until the problem has been corrected. Repairs to this telephone equipment can only be made by the manufacturer or its authorized agents or by others who may be authorized by the FCC. For repair procedures, follow the instructions outlined under the VTECH Limited Warranty.
This equipment may not be used on coinservicelinesprovidedbythe phone company or on party lines.
The REN is useful in determining the number of devices you may connect to your telephone line and still enable the devicesto ringwhen you receive a call. The general rule is that the REN value should not exceed5.OA total; however, contact your local telephone company for the specific number in your area.