VTech CS6129-54, CS6129-32, CS6128-31, CS6129-2 Battery installation and charging, Side UP facing

Page 7

Getting started

Battery installation and charging

Install the battery as shown below. After installing the battery, you might be able to make and receive short calls. For best performance, charge the handset for at least 16 hours before use. When the battery power is low, the handset will beep, display LOW BATTERY and will flash on the handset screen. Place the handset in the telephone base or charger to charge the battery when not in use. See the table on page 53 for battery operating times.

If the battery is depleted, it may take approximately four minutes to charge the handset before it can resume screen display. The screen will continue to display LOW BATTERY until the battery has been charged for approximately one hour.

			Charge
			light
1	2	3	4	5
If the battery	Plug the battery	Place the battery	Align the cover	Charge the handset
compartment	securely into the	with the label THIS	flat against	by placing it in the
cover is on the	plug inside the	SIDE UP facing	the battery	telephone base
handset, press	handset battery	up and the wires	compartment,	or charger. The
the indentation	compartment,	inside the battery	then slide it	CHARGE light
and slide the	matching the	compartment. Route	upwards until it	will be on when
cover to remove. color-coded label.		the wires through	clicks into place.	the handset is
		the slot at the		charging.
		bottom of the battery
		compartment.

•If the handset will not be used for a long time, disconnect and remove the battery to prevent possible leakage.

•To purchase replacement batteries, visit our website at www. vtechphones. com or call

1 (800) 595-9511. In Canada, go to www.vtechcanada. com or call 1 (800) 267-7377.

Getting started Basic operation

www.vtechphones.com

Image 7

Contents User’s manual Congratulations Table of contents Answering system Getting started Parts checklistTelephone Side UP facing Battery installation and chargingWall mounting Getting Handset layoutUSE light Telephone base layoutRinger volume handset Telephone settingsRinger tone Language Key toneClear voicemail INDICATOR?Home area code Speakerphone Make a callAnswer a call End a callMute VolumeRinger mute Find handset Call waitingChain dialing For model CS6129-2 IntercomConference call INT Transfer an external callCalling Handset Switch between external and intercom call Answer an incoming call during an intercom call Directory Store a directory entry Character chart Dial a directory entry Search the directoryEdit a directory entry Delete from the directory About caller ID Call log Review the call log Missed calls indicatorDial a call log entry Make a call log entry ready to dialSave a call log entry to the directory CALLS? Delete from the call logDisplays When Call log display screen messagesDial a redial entry Redial listDelete from redial Answering system and voicemail Answering systemActivate the answering system Message capacitySet the clock Set number of rings Answering system set upSet telephone base ringer Set remote access codeSet message alert tone Record your own announcement Outgoing announcementDelete your announcement Play your announcementMessage playback New message indicationOptions during playback Memo playback Delete all messagesRecord and play memos Record a memoCall intercept Call screeningWindow displays Descriptions Message window displaysCommand Function Remote accessHandset display screen messages AppendixDirectory is full Telephone base lights Handset and telephone base indicators Handset lightsNEW Handset and telephone base indicators Handset iconsBattery Important safety instructions Problem Suggestion TroubleshootingLight on the handset should be on To take place Less background noise Appendix Appendix System does CONNECTING... is Messages on To one minute for this to take place Operating range MaintenanceRbrc seal About cordless telephonesWhat does this limited warranty cover? WarrantyHow do you get warranty service? FCC Part FCC, Acta and IC regulationsAppendix Technical specifications Index Appendix Template for wall mounting studs 91-001849-050-100