VTech Mirage A100 manual Fixing your Mirage phone to a wall, Pg8, Check, Pg9

Page 6

pg8

55mm

1 Setting up

Setting up

Fixing your Mirage phone to a wall

Your phone comes with two wall fitting screws and plugs. Make sure the plugs supplied are suitable for your wall.

To fix your Mirage phone to a wall:

1 Use this template as a guide to mark the wall before drilling

Check

•that the leads reach your telephone socket and mains power supply

•that the handset will not be damaged or cause damage if it is accidently knocked off it’s base station

•the position guidelines given in this setting up guide

2Use a spirit level or plumb line to ensure the phone will hang straight

3Drill two holes where you have marked, insert the wall plugs and screws – leaving a 3mm gap between the head of the screw and the wall

4Slide the base station onto the screws

•make sure you don’t cut the telephone line or power cord, this will damage your phone and invalidate your warranty

pg9

Your phone comes with three different coloured handset covers. To change a cover:

1Gently squeeze the arrows marked on either side of the screen

2 Lift the cover and slide it away from the keypad

3Fit the two tabs at the top of the new cover into the slots on the top of the handset

4 Click the cover into place.

1 Setting up

Image 6

Contents Mirage A100 Contents If you have a heart pace maker SafetyWarranty information If you have a hearing aidStyle Network servicesInnovation SimplicitySetting up Power leadPg7 Check Fixing your Mirage phone to a wallPg8 Pg9Section contents Basic functionsVolume AndyStored Audio HS SettingsCancel HsetnameDelete NEW CallsCall LOG Delete ListEditing a number on your redial list Using redialEdit Deleting a redial numberDialling a favourite number NameKaren Deleting a favourite numberDeleting a quick dial number QuickdialDialling a quick dial number Storing or changing a quick dial numberCall Anonym InquiryAuto Redial Handset settings pg26 Netw Access ResetEnter PIN RESET? Call BarrNetwork services pg30 3Press Press several times until the display says Change Codes2Press Press Scroll to the code you want to setSwitch Call PTY CallSingle Register Enter your PIN the factory setting is PressHandsets pg36 Base aINT/COM NBR INT/COMGroup Call INT/COM INQ Transfer3PTY Call Letter shows Active base station Base stationsDEREG? De-registering a handset from a base stationThere’s no display on the handset Select BaseThere’s no dial tone My handset doesn’t ringCan hear the caller but they can’t hear me Battery icon shows a low chargeCannot make intercom calls Have spilt liquid on my handsetHandset seems to be locked Handset flashes RegisterDispaly says Same PIN BatteriesDisplay Base station