VTech gz5838 Telephone base installation, To single-line, Telephone jack RJ11C

Page 6

•If you need to install your telephone within the same room as other cordless telephones or wireless products, you may need to select a different channel for your router or change the channel on your handset..

•This power adapter is intended to be correctly oriented in a vertical

or floor mount position.. The prongs are not designed to hold the plug in place if it is plugged into a ceiling, under-the- table or cabinet outlet

Installation

Telephone base installation

Install the telephone base and the power adapter as shown below.. Choose a location away from any electronic equipment and appliances such as personal computers, computer routers, wireless routers (wireless broadband, wi-fi, or 802.11), television sets, microwave ovens and refrigerators. Avoid excessive heat, cold, dust or moisture..

Plug the connector of the power adapter to the connector jack at the bottom of the telephone base.. Then plug the power adapter into a standard electrical outlet not controlled by a wall switch..

•Connect the telephone line cord to the jack at the bottom of the telephone base, and the other end to the wall jack..

•If you receive high speed internet through your telephone line (commonly referred to as DSL) and you are experiencing interference during telephone conversations and/or your caller ID features are not functioning properly, install a DSL filter to the telephone line between the telephone base and the telephone wall jack. Contact your DSL service provider for a DSL filter.

To power outlet

AC power adapter

To single-line

telephone jack (RJ11C)

Telephone line cord

DSL filter

 

(optional for DSL users)

www.vtechphones.com

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Table of contents Page Important safety instructions CongratulationsParts checklist Before you beginInstallation Installing handset batteryTelephone jack RJ11C Telephone base installationTo single-line Telephone line cord DSL filter Optional for DSL usersRemovable handset bracket and telephone base plate Handset bracketHandset features CIDTelephone base features CHARGE/IN USETelephone operation Make, answer, and end a callCall waiting Set handset ringer Dial mode Set date and timeTemporary tone dialing LanguageDisplay screen messages Speed dial Store a speed dial entrySpeed dial Edit a speed dial entry Delete a speed dial numberDial a speed dial number Re-assign speed dial locationsDirectory Store a directory entryDirectory Edit a directory entry Delete a directory entry Move a directory entry to speed dial Caller ID About caller ID informationCall log Review call logLocate the desired record in the call log Remove records from call historyDial a displayed number Various dialing options areStore a call log entry in the directory Call log display screen messages Display WhenHeadset operation Belt clipTroubleshooting Contact your local telephone companyMode Cannot dial out First, try all the above suggestionsSecond before dialing Less background noiseLow Battery is Hear noise Using the telephoneHear other calls while Cordless handset, None of the keys or Buttons workBase Ring when there is anIncoming call Simultaneously.. Try unplugging some of themSame outlet or near a microwave oven There is noiseOr interference Telephone company charges may applyNot receive caller ID Company Or the system does Caller ID serviceDuring call waiting Caller ID service Not display caller IDBattery Important safety instructions Maintenance WarrantyWhat is not covered by this limited warranty? Operating range FCC, Acta and IC regulationsFCC, Acta and IC regulations Rbrc Seal Technical specifications Index DSLTelephone base features 91-001083-010-100 User’s manual
Top Page Image Contents