Motorola RDU2080d, RDV2080d manual Source Radio Radio to be cloned, Operating Instructions

Cloning Radios using the Radio to Radio (R2R) Cloning Cable (optional accessory)

PROGRAMMING FEATURES	Source Radio: Radio to be cloned.
	Operating Instructions

Target Radio: Radio to which the configuration of the “Source Radio” will be copied (cloned).

1.Before beginning the cloning process, make sure you have:

•A fully charged battery on each one of the radios.

•Two Single Unit Chargers (SUC).

English 58

•Both radios are turned OFF.

•Both radios are of the same radio model.

2.Unplug any cables (power supply or USB cables) from the SUCs.

3.Plug one side of the cloning cable mini connector to one SUC. Plug the other end to the second SUC.

Note: During the cloning process no power is being applied to the SUC. The batteries will not be charged. A data communication is being established between the two radios.

4.Turn ON the “Target Radio” and place it into one of the SUCs.

5.On the “Source Radio”, power the radio following the sequence below:

•Long press the Push-to-Talk (PTT) and Side Button 2 (SB2) simultaneously while turning the radio ON.

•Wait for 3 seconds before releasing the buttons until a distinctive audible tone is heard.