CLEARING PAPER MISFEEDS AND JAMS
Adjusting dual stacker tray scuffer arms
Paper jams can occur when the paper does not stack smoothly in the dual stacker trays. If some papers stack well while others do not, the weights under the scuffer arms may need to be adjusted.
Note: The scuffer arm weights on some printers are bolted in place.
These must be adjusted by a service representative.
The adjustable weights are located on the underside of the scuffer arms, on a track down the center. To adjust them:
1.Slide the weight right or left along its track under the scuffer arm.
•
•
If the paper is driven too far up the outside edge of the tray, move the weight toward the machine.
If the paper is not driven far enough into the tray, move the weight away from the machine.
Note: For lightweight paper, move the weight toward the machine; for heavyweight paper move the weight away from the machine. 
Figure 2-6. Adjusting scuffer arm weights
1
1 Scuffer arm
2.Clear all paper jams, following the jam clearance instructions provided by the message and graphic displays on the printer control console.
3.Discard any pages sent to the sample tray or to a stacker tray when the jam was detected.
4.Press the Continue button on the printer control console to resume printing.
XEROX DOCUPRINT 92C IPS TROUBLESHOOTING GUIDE |