Cisco Systems AS5800 Test vrm reset, Following example resets DSP 4 on the VFC installed in slot

test vrm reset

test vrm reset

To reset a particular DSP, use the test vrm reset privileged EXEC command.

test vrm reset {slot-number dsp-number}

Syntax Description

slot-number	Number identifing the slot where the VFC is installed.
dsp-number	Number identifying the DSP to be reset.

Defaults

No default behavior or values.

Command Modes

Privileged EXEC

Command History

Release	Modification
12.0(7)T	This command was introduced.

Usage Guidelines

Use the test vrm reset command to send a hard reset command to an identified DSP. When this command is used, any active calls on all channels associated with this DSP are dropped. Under most circumstances, you will never need to use this command.

Examples

The following example resets DSP 4 on the VFC installed in slot 2:

router# test vrm reset 4 2

Resetting voice device may termiate active calls [confirm}

Reset command sent to voice card 4 for voice device 2.

Voice over IP for the Cisco AS5800 57