VeriFone Omni 37xx manual Routing Cables Using Wire Clips, To Conduct a Smart Card Transaction

TERMINAL SETUP

Routing The Cables Using Wire Clips

Routing The

Cables Using

Wire Clips

Since the Omni 37xx terminal is a hand-over solution, make sure the cables are routed loosely. Use the two wire clips provided with each terminal to organize loose cables. See Figure 15.

Smart Card Transaction

Figure 15 Routing Cables Using Cable Wires

1Place the telephone cord and power cable into the grooves inside the wire clip.

2Close the wire clip and press the halves together until the it snaps closed.

3Unsnap the wire clip, to reposition as necessary.

The smart card transaction procedure may vary from one application to an another. Verify with your application provider before you perform a smart card transaction.

To Conduct a Smart Card Transaction

1Position a smart card with the contacts facing upward (see Figure 16).

2Insert it into the smart card reader slot in a smooth, continuous motion until it seats firmly.

22OMNI 37XX INSTALLATION GUIDE